15 Amp 30 Volt H-Bridge
1 of 2
http://www.acroname.com/robotics/parts/S24-15A-30V-HBRIDGE.html
find:
15 Amp 30 Volt H-Bridge
Last Modified: 2008-12-31
Acroname Robotics PDF webpage version
ContactTechnologiesDownloadsMissionProductsNewsSupport
Related
Products
add
To Your Basket
Ordering Information
Part Number:
Price:
Weight:
S24-15A-30V-HBRIDGE
$129.00
0.25 lbs
The h-bridge is designed for high load applications where
efficiency and capacity are critical factors. This bridge has a
15.0A continuous current capacity, can drive motors ranging
from 5.0V to 30.0V, and conforms to the Acroname
H-Bridge standard for use with any high-quality controller
including the BrainStem Moto 1.0 module.
More Details:
BrainStem Moto 1.0 Module
This H-Bridge component is a convenient way to control motors or other high-current loads. The bridge has the
following characteristics:
5.0 to 30.0 Operational Voltage
Continous current capacity rated at 15.0 Amps
CMOS/TTL compatable inputs
Low on resistance
Seperate logic and motor supply inputs
Input PWM frequency ranging from 0 to 100.0kHz
Screw terminals for motor and supply wiring
Solder pads and holes with strain relief holes for motor and supply wiring
Quadrature encoder pass through with pull up resistors
Status LEDs for motor power, logic power, system faults, direction and PWM
Product
Resources
Datasheet
IGIS 3D
CAD
model
3 AMP Low Voltage H-Bridge
Wiring Interfaces
Acroname designed the H-Bridge to allow for the most ideal wiring interface for your system. Screw terminals,
solder holes and pads, and strain relief holes provide a number of different wiring combinations most appropriate
for your system. One potential wiring interface is to insert both motor power and interface wires into the
attached screw terminals.
3A Back EMF H-Bridge
Another option is to utilize the strain relief holes. One recommended interfacing approach is to run wires up
through the strain relief holes and solder wires to the appropriate pads or through holes. A combination of these
options are shown in the following figure.
9/27/2009 2:22 PM
15 Amp 30 Volt H-Bridge
2 of 2
http://www.acroname.com/robotics/parts/S24-15A-30V-HBRIDGE.html
1A Stepper Motor Bridge
Dimensions
All dimensions are in inches.
Devantech MD22 Motor Driver
HBridge Extender Cable
Related Links:
Acroname Supported H-Bridge Standard
Driving High-Current Loads from Logic Article
H-Bridge Motor Driver Chip
voice: 720-564-0373, email: sales@acroname.com, address: 4822 Sterling Dr., Boulder CO, 80301-2350, privacy
© Copyright 1994-2009 Acroname, Inc., Boulder, Colorado. All rights reserved.
9/27/2009 2:22 PM