1741571 CetraFabricReplacement

advertisement
Systems Assembly Instructions
Cetra®
Page 1 of 2
Fabric Replacement for
Spline Application
Figure A
Pry out spline
Tools Required
■
■
■
Spline Roller
Rubber Mallet
Scissors, Utility Knife,
Electric Shears or
Heat Knife
■
■
Wide Flat Blade Screwdriver
Narrow Flat Blade Screwdriver
or Needle Nose Pliers
Figure B
Completely pull out spline
Package Contents
■
■
Panel Fabric
Spline
■
■
Spline Roller (Thick)
Spline Roller (Thin)
Installation
1. On the panel, find the end of the spline or pry it out any
place with a narrow flat blade screwdriver, needle nose
pliers, or similar pointed object. (Figure A).
2. Completely pull out full length of spline and remove fabric
from panel. (Figure B).
3. Lay out new fabric on panel. Fabric piece should have at
least 2" extra on all sides. Please pay particular attention to
the fabric orientation and make sure it is the same direction
as the fabric on the panels already in place. (Figure C).
4. Begin pushing new spline back in groove on panel with
thick spline roller or wide flat blade screwdriver, capturing
the fabric in the groove as you proceed. DO NOT fully seat
the spline at this time. (Figure D).
Figure C
2" extra on all sides
Figure D
Insert new spline
Thick spline roller
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741571
Revision B-04
Systems Assembly Instructions
Cetra
Page 2 of 2
Installation (continued)
Figure E
5. Pull fabric firmly and evenly while carefully working around
the panel with the spline roller or screwdriver. Watch the
thread line so as to not distort the fabric. (Figure E).
6. Carefully trim excess fabric. (Figure F).
7. Go around the entire panel and completely seat the
spline into the panel groove using the thin spline roller.
(Figure G).
8. Tuck all corners in with a screwdriver and rubber mallet.
(Figure H).
Pull fabric firmly
and evenly
Figure F
Tuck in all corners
Fully seat spline in groove
Thin spline roller
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741571
Revision B-04
T 800.482.1818
Figure H
Printed in U.S.A. © 2004 Kimball International, Inc.
Figure G
F 812.482.8300
Trim excess
Download