Australian/New Zealand
Certification Scheme for
E XPLOSION- P ROTECTED E LECTRICAL E QUIPMENT
ANZEx Scheme
Certificate of Conformity
Certificate No.: ANZEx
08.4075X
Issue No.:
0
Date of Issue:
Certificate Holder:
CSE.Ex Pty. Ltd.
122 Canterbury Road
Padstow, New South Wales, 2211
Australia
Electrical Apparatus:
‘EZF’ Series HID Bulkhead Luminaires
‘EMF’ Series Bulkhead Luminaires and Beacons
Type of Protection:
Ex d IIB + H2
Marking Code:
Ex d IIB + H2 T* IP66
20 December 2008
(*refer to Schedule of Models on Pages 3+4)
ANZEx 08.4075X
Manufacturing Location(s):
CSE.Ex Pty. Ltd.
122 Canterbury Road
Padstow, New South Wales, 2211
Australia
.
This certificate and schedule shall not be reproduced except in full
Certificate issued by
ITACS Pty. Ltd.
4-6 Second Street SA 5007 Australia
PO Box 300 Hindmarsh SA 5007 Australia
ABN 06 098 886 563
Phone: +61 8 8346 8680 Fax: +61 8 8346 7072
Email: itacs@itacslab.com
Accreditation by the Joint
Accreditation System of
Australia and New Zealand
Acc No. Z2870404AA
www.jas-anz.com.au\register
Page 1 of 6
Australian/New Zealand
Certification Scheme for
E XPLOSION- P ROTECTED E LECTRICAL E QUIPMENT
ANZEx Scheme
Certificate No.: ANZEx
08.4075X
Issue No.:
0
Date of Issue:
20 December 2008
This certificate is granted subject to the conditions as set out in Standards Australia/Standards New Zealand Miscellaneous
Publication MP87.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified
documents, was found to comply with the following standards:
AS 2380.1 - 1989
Electrical equipment for explosive atmospheres –
Explosion-protection techniques – General requirements (inc Amdt 1)
Electrical equipment for explosive atmospheres –
Explosion-protection techniques – Part 2: Flameproof enclosure ‘d’
AS 2380.2 - 1991
Degrees of protection provided by enclosures of electrical equipment (IP
code)
AS 1939 – 1990
This Certificate does not indicate compliance with electrical safety and performance requirements other than
those expressly included in the Standards listed above. Attention is drawn to the fact that these Standards have
been superseded.
TEST & ASSESSMENT REPORTS:
The equipment listed has successfully met the examination and test requirements as recorded in
Test Report No. and Issuing Body:
Quality Assessment Report No. and Issuing Body:
ITACS 4657
IECEx ITA/QAR 07.0003/01
File Reference: ANZEx 08.4075X
Signed for and on behalf of issuing body
Certification Authority
Position
20 December 2008
Date of Issue
This certificate and schedule shall not be reproduced except in full
This certificate is not transferable and remains the property of the issuing body
and must be returned in the event of it being revoked or not renewed.
Page 2 of 6
Australian/New Zealand
Certification Scheme for
E XPLOSION- P ROTECTED E LECTRICAL E QUIPMENT
ANZEx Scheme
Certificate No.: ANZEx
08.4075X
Issue No.:
0
Date of Issue:
20 December 2008
Schedule
EQUIPMENT:
CSE.Ex, CSE or Pierlite ‘EZF’ Series HID Bulkhead Luminaires:
The Series EZF HID Bulkhead Luminaires comprises a cast aluminium body which houses a gear tray, reflector
and lamp. The lamp is protected by a screw on lens assembly forming a threaded flamepath with the body. The
luminaire incorporates a mounting bracket which also forms a threaded flamepath with the body. The mounting
bracket is available in wall, ceiling, pendant and stanchion mount. The Luminaires included in the range are
summarized in Table 1.
Cat No.
Lamp Wattage
Lamp Type
Temperature
Classification
(W)
EZF400MH
400
MH
T3
EZF250MH
250
MH
T4
EZF175MH
175
MH
T4
EZF400HPS
400
HPS
T3
EZF250HPS
250
HPS
T4
EZF150HPS
150
HPS
T5
EZF400MV
400
MV
T3
EZF250MV
250
MV
T3
EZF125MV
125
MV
T5
Table 1: summary of certified EZF luminaires
CSE.Ex, CSE or Pierlite ‘EMF’ Series Bulkhead Luminaires and Beacons:
The EMF Range of Bulkhead Luminaires (and beacons) comprises a cast aluminium body which houses the
gear tray, reflector and the lamp holder. The lamp is protected by a screw on lens assembly forming a threaded
flamepath with the body. The mounting arrangement screws onto the opposite end of the body forming another
threaded flamepath. Mounting brackets are available in four styles: Wall, ceiling, pendant and stanchion. The
range of fittings included in the range is summarised in Table 2.
This certificate and schedule shall not be reproduced except in full
Page 3 of 6
Australian/New Zealand
Certification Scheme for
E XPLOSION- P ROTECTED E LECTRICAL E QUIPMENT
ANZEx Scheme
Certificate No.: ANZEx
08.4075X
Cat No,
Issue No.:
Lamp Wattage
0
Date of Issue:
20 December 2008
Lamp Type
Temperature
Classification
(W)
EMF300GLS
300
GLS
T3
EMF200GLS
200
GLS
T4
EMF150GLS
150
GLS
T5
EMF100GLS
100
GLS
T5
EMF2 x 18PLC
2 x 18W
PLC
T6
EMF70MH
70
MH
T5
EMF70HPS
70
HPS
T5
EMF50HPS
50
HPS
T6
EMF80MV
80
MV
T5
EMF50MV
50
MV
T6
Table 2: summary of certified EMF luminaires
CONDITIONS ON CERTIFICATION
Conditions of manufacture
1.
The Mg content of the aluminium labels must be controlled not to exceed 6% Mg.
Conditions of safe use
1.
The equipment shall be utilized with suitable certified adaptors, cable glands and / or conduit sealing
devices.
2.
Any unused entries shall be suitably sealed with certified blanking elements.
This certificate and schedule shall not be reproduced except in full
Page 4 of 6
Australian/New Zealand
Certification Scheme for
E XPLOSION- P ROTECTED E LECTRICAL E QUIPMENT
ANZEx Scheme
Certificate No.: ANZEx
08.4075X
Issue No.:
0
Date of Issue:
20 December 2008
DRAWINGS:
‘EZF’ Series HID Bulkhead Luminaires
Document No.
Document Title
Issue
Date
C2030
EZF Geartray
2
22/10/02
C2138
Wires/Terminals
2
16/11/94
C2139
Bracket, Ignitor
1
29/3/94
C2159
Leaflet, Earth Installation
1
4/4/95
C2022-1
EZF-P Wellglas General Assembly
3
25/2/97
C2023-1
EZF-C Wellglas General Assembly
3
25/2/97
C2024-1
EZF-B Wellglas General Assembly
3
25/2/97
C2025-1
EZF-S Wellglas General Assembly
3
25/2/97
C2026-1
EZF-P Wellglas General Assembly
3
25/2/97
C2027-1
EZF-C Wellglas General Assembly
3
25/2/97
C2028-1
EZF-B Wellglas General Assembly
3
25/2/97
C2022-2
Wellglass Assembly
4
2/2/98
C2023-2
Wellglass Assembly
4
2/2/98
C2024-2
Wellglass Assembly
4
2/2/98
C2026-2
Wellglass Assembly
4
2/2/98
C2027-2
Wellglass Assembly
4
2/2/98
C2028-2
Wellglass Assembly
4
2/2/98
C2029-2
Wellglass Assembly
4
2/2/98
EZF-2
Fused Terminal Block Arrangement
1
17/2/98
C2164
Label, Warning
6
5/2/99
C2165
Label, Clipsal Logo
6
5/2/99
C1992
EZF label, Rating
8
18/11/08
EZF-1
EZF Label, Label, Rating. 120…230V, 50/60HZ
4
18/11/08
C2025-2
EZF-S Wellglass General Assembly
5
1/9/00
C2029-1
EZF-S Wellglass General Assembly
4
1/9/00
This certificate and schedule shall not be reproduced except in full
Page 5 of 6
Australian/New Zealand
Certification Scheme for
E XPLOSION- P ROTECTED E LECTRICAL E QUIPMENT
ANZEx Scheme
Certificate No.: ANZEx
08.4075X
Issue No.:
0
Date of Issue:
20 December 2008
‘EMF’ Series Bulkhead Luminaires and Beacons
Document No.
Document Title
Issue
Date
C1453
Wiring Diagram – Single GLS
3
14/6/94
C1459
Wiring Diagram – M.H. & H.P.S. (250 V 50 Hz
capacitor)
4
15/5/96
C1463
Wiring Diagram – Single Compact (2P) (250 V 50
Hz capacitor)
4
15/6/94
C2081
EMF Brackets, Cap.
1
19/5/95
C2082
EMF Brackets, Choke
1
18/5/95
C2083
EMF Clamp, Igniter
1
19/5/95
C2159
EZF Leaflet, Earth Installation
1
4/4/95
C2420
EMF Wellglass General Assembly
4
18/11/08
C2424
EMF Reflector
1
27/7/95
C2077
Wellglass General Assembly
6
2/2/98
C2078
Wellglass General Assembly
6
2/2/98
C2079
Wellglass General Assembly
6
2/2/98
C2080
Wellglass General Assembly
8
1/9/00
EMF-4
Fused Terminal Block Arrangement
1
17/2/98
C2165
Label Clipsal LOGO
8
19/9/06
C2164
MVMH, MVLH, BLDN, MBDN, VMDN, EZF,
EMF Label Warning
6
5/2/99
C1635
Wiring Diagram – M.V.
5
11/4/97
C2352
EMF Label, Rating
7
18/11/08
EMF-1
EMF Label, Rating 120-230 V, 50/60 Hz
4
18/11/08
EMF-0008Z
Wellglass Beacon General Assembly
2
11/9/00
This certificate and schedule shall not be reproduced except in full
Page 6 of 6