Page1 of 6 5 Super Flux LEDs Waterproof LED Module 5 Piranha LEDs Waterproof LED Module Part Number(型号): RFS78-5X Series The super flux LED modules has 3 super flux lEDs resin sealed into a plastic case making them suitable for use outdoors,or in wet environments.They are IP68 rated and never got hot.Very energy efficient.20 modules use just 3.8W to 7W depending on the led colour,,easier jobsite installation(splice connector or twist-on wire connector and 3M double-faced sticking tape), free maintenance and more consistent brightness. Customer segments: Retail, restaurant, hospital, grocery and casino Standard Version: 50,000 hrs span life.3 years’ warranty. Economy Version: 30,000 hrs span life.1 year’s warranty. Customer segments: Retail, restaurant, hospital, grocery and casino Standard Version: 50,000 hrs span life.3 years’ warranty. Economy Version: 30,000 hrs span life.1 year’s warranty. Page2 of 6 Features ·High Brightness RightLEDs 5 piranha LEDs Waterproof LED Modules consist of 5 piranha LEDs in high intensity and can emit higher brightness at lower cost. Bigger chip in LED. No spot. No shadow ·Easy Installation RightLEDs 5 piranha LEDs Waterproof LED Modules can be easily installed with 3M double-sided sticking tape and connectors. ·Extended Life With little heat, proper drive characteristics and high quality LEDs, RightLEDs 5 piranha LEDs Waterproof LED Modules have a life time of more than 30,000 hours. ·Totally waterproof With IP68 protection degree, RightLEDs 5 piranha LEDs Waterproof LED Modules can operate normally in cloudy, rainy, desert, and snowy weather conditions and pool. The Piranha LEDs are totally covered by resin. ·Friendly environment Pb free. With CE/RoHS/SGS certificate, RightLEDs 5 piranha LEDs Waterproof LED Modules are up to 60% more energy efficient than neon. ·Safe Application Low voltage DC12V, safety and stable. Free maintenance 模 LED技术参数/LED Technical Specification LED 5mm(3mm) Head Piranha LED. 5 mm(3 mm)食人鱼 LED Color/Wave Red Yellow Blue Green White length 625±5nm 590±2nm 467±3nm 525±3nm 7000/5000k MCD/亮度 1200~1500mcd 1200~1500mcd 800~1200mcd 2000~4000mcd 1500~2500mcd Beam Angle/ ±95/±110Degree Arima Arima Huga Epistar Huga 14*14mil 14*14mil 12*13mil 12*13mil 12*13mil 1.9~2.3v 1.9~2.3v 3.0~3.4v 3.0~3.4v 3.0~3.4v 颜色/波长 角度 Chip/芯片 Voltage LED模块技术参数/LED Module Specification Dimension/尺寸 80*15*12mm LED No/数量 5 pcs Piranha LED Voltage/电压 Input DC12v(e)/Input DC12v~24v.(s) Current/电流 18mA 18mA 18mA 29mA 29mA Watts/功率 0.432 0.432 0.432 0.348 0.348 Lumen/亮度 13~17.5 4~7.5 16~20 7~8.5 7~11 Color/颜色 White Green Yellow Red IP/防护等级 IP68 The PCB be covered by resin. Blue Beam angle/角度 90~110Degree Page3 of 6 Part No/型号 RFS78-5W NO.1 RFS78-5B RFS78-5G RFS78-5Y NO.2 RFS78-5R NO.20 注意Note: 角度有 30/60/110 度供选择 30/60/110 Degree also available as per customers’ request 产品分为超高亮度和高亮度 Standard version(s)/Economy version(e) 只有高亮度会赠送双面胶 Only Standard version LED Module with 3M double-sided sticking tape 高亮度每个串联可高达 100 个 Max 20pcs per strip(e). Max 100pcs per strip(s) 所有模块提供防水与不防水产品。Both waterproof and non-waterproof are avaible. Copyright © 2001-2008 RightLEDs Co,. Ltd Tel: 86-755-2765 6979 Fax: 86-755-2765 6780 Web: www.RightLEDs.com E-mail:susan@rightleds.com Page4 of 6 适配电源/Relative Products & Accessories 电源型号/LED Power Supplies Part Number Input Voltage Output Voltage Watts Load(Quantity of led module) 型号 输入电压 输出电压 功率 负载 30 W/B//G 71pcs R/Y 38pcs RP12-50W 50 W/B/G 119pcs R/Y 64pcs RP12-60W 60 W/B/G 143pcs R/Y 77pcs RFP12-80W 80 W/B/G 191pcs R/Y 103pcs RP12-100W 100 W/B/G 239pcs R/Y 129pcs RP12-150W 150 W/B/G 358pcs R/Y 193pcs RP12-200W 200 W/B/G 478pcs R/Y 258pcs RP12-300W 300 W/B/G 725pcs R/Y 387pcs RP12-350W 350 W/B/G 837pcs R/Y 454pcs RP12-400W 400 W/B/G 956pcs R/Y 519pcs RP12-700W 700 W/B/G 1674pcs R/Y 909pcs RP12-1000W 1000 W/B/G 2392pcs R/Y 1298pcs RP12-30W 220v DC12v 注意/Note * 所需电源功率:单个模块功率*模块数量*1.1。Formulation=Watts per module*No of Module*1.1 * 注意配合适功率电源。Please ensure the power supply is of adequate power to operate the total load. * 注意正负极连接正确。Correct electrical polarity needs to be observed. * 注意连接点。Assembly must not damage or destroy conducting paths on the circuit board. 安装连接示意图/Installation Guide 15MM 15MM 60MM Copyright © 2001-2008 RightLEDs Co,. Ltd Tel: 86-755-2765 6979 Fax: 86-755-2765 6780 Web: www.RightLEDs.com E-mail:susan@rightleds.com Page5 of 6 1. Clean surface of channel letter. Arrange the module in order 清理字表面,撕下背面双面 胶,贴到字内. 2. Fix wires with splice connector or twist-on wire connectors 使用电线防水压扣连接各个 点 3. Turn on power supply 接通电源. Notice 1. 每第 21 个模块必须外接另一根电源线,每串 模块必须和电源线并联.Each 20 Unit should be connected in a power loop 2. 电源线离电源的距离不得超过 5 米.Max 5 meters between 3. power supply and Unit 电源线所带的 LED 模块的电流不得超过电 源线的正常工作电流 The right power cable should be noticed 4. 所有安装结束前不能接通电源 Turn power off before inspection, installation. 5. 确 保 金 属 外 壳 电 源 必 须 接 地 .Make sure Ground wire is connected properly 6. 每平方推荐使用 120~150 个模块.300pcs per square meters 7. 同一批字使用同批次模块,以免出现色差. Copyright © 2001-2008 RightLEDs Co,. Ltd Tel: 86-755-2765 6979 Fax: 86-755-2765 6780 Web: www.RightLEDs.com E-mail:susan@rightleds.com Page6 of 6 Trouble shooting 故障分析 Symptom 现象 Condition 原因 Solution 解决方法 All letters are off No AC input 所有字不亮 没有连接电源 Attach AC Input and /or check circuit breaker 连接电源并检查各连接点 Incorrect wire attachment 线路连接不正确 Check wire connections between strips and power supply for improper terminations or short circuits. Properly terminate or replace the wire connections 查看所有连接点,看是否短路。 Some LEDs appear Overload dim 电源过载 一些 LED 亮度不够 Ensure the overall length of strip does not exceed the maximum load of power supply 减少模块数量或更大功率电源 Some letters have different color temperature or color variation within a letter Maximum recommended supply wire length exceed Reduce the length of supply wire equal to or below the recommended maximum 主连接线线径不够,主线过 拉紧电源与字距离,增加主线直径,使主线 长。 能够通过更大电流。 Mixed part No of LED module within the letter Make sure that all LED module have the same color temperature/wave length 混乱使用不同批次模块 保证同一批字使用相同批号的模块 Mixed part No of LED module within the letter Make sure that all LED module have the same color temperature/wave length 混乱使用不同批次模块 保证同一批字使用相同批号的模块 Wire connections or supply wire laying over on LED module Re-route supply wire and secure to the back of the can with silicone. Adjust wire connector orientation so that it does not cover LEDs 字发光颜色不一致 Shadows 字中有阴影 字中连接线覆盖到 LED 用硅胶固定主线,注意模块直接连接线位置。 Improper position of LED Module Reposition 增加 LED 模块数量。使模块处于同一表面。 使用 LED 模块过少或位置不 当 Spot 有光斑 Minimum length between LED module and cover of letter does not reach. Exchange to other type LED module with wider angle.100mm recommended for Piranha LED module LED 模 块 与 字 表 面 距 离 太 使用草帽/贴片 LED 模块,或使用大角度食人 短。应在 10 公分以上 鱼模块。 Copyright © 2001-2008 RightLEDs Co,. Ltd Tel: 86-755-2765 6979 Fax: 86-755-2765 6780 Web: www.RightLEDs.com E-mail:susan@rightleds.com