T5-D LED Tube
PERFORMANCE AND WARRANTY
Power Input
230V – 240V ~ 50Hz
Lengths
600mm / 900mm / 1,200mm / 1,500mm
Power Options
T5-D LED Tube
8W / 10W / 15W / 17W / 20W / 24W / 30W
Max Output (UT Chip)
1,072lm / 1,340lm / 2,010lm / 2,278lm / 2,680lm / 3,216lm / 4,020lm
Efficacy (subject to lens)
EF: 119lm/W | UT: 134lm/W
Colour Temperature Options
3,000k / 4,000k / 5,000k / 6,000k
Ra Options
75 / 85 / 95
LED Driver IP Rating
IP22
Luminaire IP Rating
IP30
Power Factor Correction
> 0.94
UT Warranty
5 Years L70
EF Warranty
5 Years L 85
UT Lifetime @ Ta 25ºC
L70 > 65,000hrs
EF Lifetime @ Ta 25ºC
L 85 > 125,000hrs
Thank you for selecting the BLS® T5-D as your LED solution. At BLS® we are dedicated to ensuring that
our products provide years of maintenance free, reliable full spectrum light across a range of standard
colour temperatures. All BLS products are designed and specified in New Zealand and designed for
®
both new build and retrofit applications.
An ideal replacement for the T5
fluorescent, the BLS® T5-D LED
is energy efficient, longer lasting,
and maintenance free, with a
lower glare factor.
IMPORTANT:
This product is only suitable for installation by a qualified electrical contractor.
For information regarding this product or if you have any questions relating to
Business Lighting Solutions Ltd. www.bls.co.nz
79 St Georges Bay Road, Parnell, Auckland 1052. PO Box 60 360, Titirangi, Auckland 0642, New Zealand.
BLS-T5D-INS-0615-1
its use, please contact BLS® before attempting to install the product.
T5-D LED Tube
PRODUCT CODES
–
T5
XXXX
–
WIRING
X
–
XX
–
XX
–
XXXX
–
XXW
Length
Lens
LED
Ra
Temp ºK
Power (W)
0600
S
UT
75
3,000
08W
0900
F
EF
85
4,000
10W
95
5,000
15W
1200
1500
6,000
–
D
Ext. Driver
230-240V
50Hz
17W
0.5A Fuse
E
LED Driver
230Vac Input – SELV out
BLS® T5-D LED Tube
20W
24W
BLS Drivers are supplied 1-10 dimming capable as standard. Dimming controls not included.
30W
INSTALLATION INSTRUCTIONS
IMPORTANT READ BEFORE INSTALLING:
DO NOT CONNECT TO MAINS POWER DIRECTLY - This product is only suitable for use
with SELV drivers only.
IN THE BOX:
BLS® manufactures a range of SELV LED drivers to support this product, and can provide advice on a
range of approved third party alternative products. Warranty may be effected by the use of alternatives not
approved by BLS® directly.
• End caps rotate into tombstone using finger wheel.
• A flat face is provided on the hub, for use with a small spanner where the fixture is tight.
• A decorative cover is provided to dress over the T5 end caps. (Optional).
• Decorative cover is not required to ensure compliance with AS/NZS 3000 or AS/NZS 3820.
• BLS T5-D LED Tube ~ Class III Safety Extra Low Voltage (SELV)
®
INSTRUCTIONS:
• Ensure the fitting is disconnected from the mains prior to re-wiring the fixture.
• Check for damage or signs of ageing with the existing end caps and replace if necessary.
• Disconnect the ballast and starter from the circuit.
WARRANTY
The LED tube is provided with a five year warranty to L85 where EF chip is specified or five years to L70
where UT is specified. All drivers supplied with products carry a three year warranty unless an additional
warranty period is provided in the terms and conditions and sales contract supplied.
• Remove fluorescent from circuit to meet EECA COC requirements.
• Replace fluorescent ballast with LED driver, maintaining existing fused connector and replace with
0.5A fuse if required.
• Connect the Live (+) & Neutral (–) as per illustration on the right, ensuring all electrical work is in line with
AS/NZS 3000.
NOTE: END CAPS THAT ARE DAMAGED AND OTHER POOR CONNECTIONS WITHIN THE
CIRCUIT MAY PRESENT A FIRE HAZARD, CAUSE DAMAGE AND OR VOID THE PRODUCT
WARRANTY. PLEASE CHECK THE FITTINGS CAREFULLY AND ENSURE SOUND CONNECTION
PRIOR TO ENERGISING THE LAMP.
• Dispose of waste materials responsibly – recycling leaky fluorescent tubes and drivers at a suitable facility.
• Once the light fitting has been adapted correctly and in line with these instructions BLS® accepts
responsibility for luminaire compliance. Multiple tubes may be connected in series in line with AS/NZS
and providing they do not breach 0.5A max.
Business Lighting Solutions Ltd. www.bls.co.nz