ActivBoard Adjustable System
Removal and Refitting of the Actuator
Version 3
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 1
2/14/14 11:39 AM
Removal and Refitting of Actuator
2
Contents
About this document
3
Removal of ActivBoard
4
Removal of Actuator 5
Removal and Refitting of Actuator for ActivBoard Adjustable System
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 2
2/14/14 11:39 AM
Removal and Refitting of Actuator
About this document
About this document
This document shows how to remove an actuator from a ActivBoard +2 version 3 system
Requirement
Required for safe removal of the actuator from an AB+2 version 3 stand. Failure to follow this document
may cause injury and/or damage.
Equipment Required
Pozi 2/Phillips 2 screwdriver
Prior to commencing work
Ensure power is disconnected from the system
3
Removal and Refitting of Actuator for ActivBoard Adjustable System
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 3
2/14/14 11:39 AM
Removal of the ActivBoard
Removal and Refitting of Actuator
Disconnect DC Supply
1
Disconnect Audio
2
Disconnect USB
3
A
Move A & B to allow
board removal
Lift the board upwards and
remove the board from
the stand
This will reveal the frame and
actuator cover
4
B
4
5
Removal and Refitting of Actuator for ActivBoard Adjustable System
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 4
2/14/14 11:39 AM
Removing Actuator
Removal and Refitting of Actuator
• Remove the 4 securing screws
shown
• Lift the cover forward and up
1
The frame needs to be secured.
• These are to be located
through the frame and
through the holes in the
side of the vertical extrusions
(shown in image A & B
opposite )
• Use long bolts (minimum
80mm x 8mm) (shown in
image C opposite )
A
B
2
• If this is not possible due
to the actuator failing at a
lower/higher height, remove
the projector to reduce the
weight on the frame, lift/
lower the frame to locate
the bolts.
C
Remove top securing pin
Under no circumstances should
an actuator be removed until
the frame is secure following the
instructions in point 2
5
3
Removal and Refitting of Actuator for ActivBoard Adjustable System
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 5
2/14/14 11:39 AM
Removal and Refitting of Actuator
• Remove 2 securing screws –
top rear spine
1
• Remove the 2 securing screws
– lower rear spine
2
• Lift the rear of the spine and
away from location
3
Removing Actuator Continued
• Top cover crew exposed
4
A
Disconnect
• Control cable (A)
5
• Actuator power supply (B)
B
Remove the securing pin at the
bottom of the actuator
Refit the actuator in the reverse
of the above instructions.
6
6
Removal and Refitting of Actuator for ActivBoard Adjustable System
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 6
2/14/14 11:39 AM
Removal and Refitting of Actuator
7
Notes
Removal and Refitting of Actuator for ActivBoard Adjustable System
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 7
2/14/14 11:39 AM
Removal and Refitting of Actuator
8
Notes
Removal and Refitting of Actuator for ActivBoard Adjustable System
ActivBoard Actuator Removal from Adjustable System Version 3_0214V1.indd 8
2/14/14 11:39 AM