POWER-FC ECR33 / ER34 (RB25DET) D-Jetro Installation
This Power FC Application is a limited edition application. When setting
this Power
FC, please be sure to consult with a Direct Authorized A’PEXi
Power Excel Tuning Shop for setting/tuning of this parti cular Power FC .
In
order
following
to
use
this
instruc tions.
product
For
correctly,
standard
please
operation,
be
sure
。
refer
to
to
read
the
Power
FC
Instruction Manual for correspondance.
Optional Parts Required:
①
②
③
Intake Air Temp. Sensor .......................... Part No. N3A118845
Intake Air Temp. Sensor Harness............... Part No. 415-XA03
MAP Sensor (3Bar)......... .......................... Part No. 499-X001＊
＊
If using Power FC Boost Control Kit (Part No. 415-A001 / 415-A013) optional parts ③, ④
are included in the kit and are not required as seperate purchase
④ -1 M A P S e n s o r H a r n e s s ( E C R 3 3 ) . . . . . . . . . . . . . . . . . . . . . P a r t N o . 4 9 C - A 0 0 2 ＊
④ -2 M A P S e n s o r H a r n e s s ( E R 3 4 ) . . . . . . . . . . . . . . . . . . . . . . . P a r t N o . 4 9 C - A 0 0 4 ＊
Installation Procedures:
1. Tap the Intake Manifold with thread ( M 1 0 x P 1 . 2 5 ) f o r I n t a k e A i r T e m p . S e n s o r
2. The below diagram shows where to splice in for the Intake Air Temp.
Harness.
Intake Air Temp. Sensor Harness Installation:
IAT Sensor
Power FC
IAT Signal
Cut the wire and make
an input connection
from the IAT sensor
harness.
Diagram
Sensor Ground
IAT Signal
(factory exhaust gas temp. signal)
IAT Sensor
Harness
Sensor Ground
Diagram
Splice and Insulate
Sensor Ground
Harness side wiring will not be used, please
be sure to insulate
IAT Signal
(factory exhaust gas temp. signal)
3. Connect the MAP Sensor to MAP Sensor harness and into the designated side connector on the Power FC.
4. Install MAP Sensor vacuum line off of the Intake Manifold.
CONTACT:
APEX Integration, Inc.
1449 W. Orange Grove Ave., Unit A
Orange, CA 92868
Tel: 714-685-5700
Instruction Manual No.7507-1090 -01
2013/10