TOWN SQUARE® 24"
PEDESTAL SINK
FIRECLAY
TOWN SQUARE® 24" PEDESTAL SINK
•
•
•
•
•
American classic design
Clean straight lines with classic ogee curves
Rear overflow
Supplied with mounting kit
Design-matched to Town Square fixture
and faucets
• Right Height™ for greater comfort during use
• Made from fireclay
❏ 0790.400 Faucet holes on 4" (102mm) centers
❏ 0790.800 Faucet holes on 8" (203mm) centers
❏ 0790.100 Center hole only
Nominal Dimensions:
24" x 20-1/4" x 35-1/2"
(610 x 514 x 902mm)
Separate Components:
❏ 0790.004 Pedestal top 4" (102mm) centers
❏ 0790.008 Pedestal top 8" (203mm) centers
❏ 0790.001 Center hole only
❏ 0031.000 Pedestal only
* See faucet section for additional models available
4"
(102mm)
5/8"
(16mm)
20-1/4"
(514mm)
1-3/4" DIA.
STD. DRAIN
OUTLET
PED TOP
OUTLINE
PED BASE
OUTLINE
24"
(610mm)
3-3/4" (95mm)
DRAIN
CHASE
7-1/2"
(191mm)
3/8" (10mm) DIA.
SLAB ANCHOR
SCREW HOLES
ON 18-3/4" (476mm)
CTRS
6"
(152mm)
SUPPLIES AS
REQUIRED
1-1/4" O.D.
WASTE
*24"
(610mm)
To Be Specified:
❏ Color:
❏ Town Square Faucet:
❏ Centerset Lavatory Faucet: 2555.201 (shown)
❏ Widespread Lavatory Faucet: 2555.801
❏ Other Lavatory Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
2-5/8"
(67mm)
9-1/2"
(241mm)
Bowl sizes:
14" (356mm) wide
11-3/4" (298mm) front to back
6-1/2" (165mm) deep
Compliance Certifications Meets or Exceeds the Following Specifications:
• ASME A112.19.9M for Non-Vitreous Ceramic
• CAN/CSA B45 Series
18-3/4" (476mm)
4"
(102mm)
FINISHED WALL
*22"
(559mm)
3/8" (10mm) DIA.
BASE ANCHOR
SCREW HOLES
ON 6" (152mm)
CTRS
35-1/2"
(902mm)
28"
(711mm)
OPEN
TO
FLOOR
10"
(254mm)
FINISHED
FLOOR
6"
(152mm)
NOTES:
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
*SUGGESTED.
▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.
■ FOR REINFORCEMENT ONLY. TAKE ACTUAL DIMENSIONS FROM
FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9M.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
J4
© 2006 American Standard Inc.
Revised 5/06