spec sheets

advertisement
Ambulance Digital Monitor
The Alarm Set-Up:
To examinee the current alarm set-point, press both the “Silence” and “Push To Test” buttons at the same times. The alarm
set-point will be displayed with all of the decimal points lit. The
unit is shipped with the monitor set at 500 psi.
To change the alarm set-point, press both the “Silence” and
“Push To Test” buttons. The current alarm point will be displayed on LED. Hold both buttons for five seconds until the
number 1.0.0. is displayed.
Oxygen Monitor with
5” * 5.5” chrome trim plate
Release both buttons and press the “Push To Test” button to
increase the set-point by one psi. Once the desired set-point
is reached, press the “Silence” button to save the set-point. The
display will then show:
The word “On” indicates that the repeat alarm is on. This function will cause the alarm to repeat (latch) every 2 minutes, until
the empty cylinder has been replaced. This function can be
turned off by pressing the “Push To Test” button.
Once the Repeat function is set, press the “Silence” button to
save the alarm set-point and the repeat function.
Oxygen Monitor with
4” * 5.25” grey aluminum trim plate
NOTE: When the repeat functions is turned On or Off, the
alarm set-point must be re-set. Pressure must be applied to the
transducer in order to adjust alarm setting.
1
Technical Specifications
ignition +12 VDC (orange)
transducer power (red)
input (white)
ground (black)
ground (black)
3,000 psi
transducer
12 volt battery
Note: The Ambulance Digital Monitor is operated using 12 VDC. It is calibrated for 3,000 psi with a 2 foot lead harness. The
audible alarm is pre-set to be activated at 500 psi, but can be adjusted.
Model Numbers
Single unit oxygen monitor
5” x 5.5” chrome trim plate:
Single unit oxygen monitor
4” x 5.25” grey aluminum trim plate:
Z-TH9002-N
Z-TH9002
Amico Corporation 85 Fulton Way, Richmond Hill, ON L4B 2N4, Canada I 71 East Industry Court, Deer Park , NY 11729, USA
Toll Free Tel: 1.877.462.6426 | Toll Free Fax:1.866.440.4986 Tel: 905.764.0800 | Fax: 905.764.0862
APE-AMBDIGMONITOR-V1 PRINTED MAY 07
www.amico.com
2
Download