Video adapter board
SAT 0074
TI Information – Selective Disclosure
Top view (4/15/2014)
Camera
1
TI Information – Selective Disclosure
Camera
2
Camera
3
Bottom View (4/15/2014)
Radar
Deserializer
and
CPLD
TI Information – Selective Disclosure
Power
Supplies
MCU
L1 location (bottom side)
TI Information – Selective Disclosure
L1 (8mm height) inductor on bottom side
Location coordinates:
X: +1550 mils
Y: -4050 mils
Height: 8mm
TI Information – Selective Disclosure
Camera 1 connector (ribbon cable)
• Camera 1 parallel data
• Camera 1 PCLK, Vsync, Hsync
• I2C #3
TI Information – Selective Disclosure
Camera 2 connector (ribbon cable)
• Camera 2 parallel data
• Camera 2 PCLK, Vsync, Hsync
• I2C #3
• 4 discrete lines
–
–
–
–
PWR_MCU_Master_Slave
DES_MCU_Master_Slave
DES_MCU_Data_Available
PWR_MCU_Data_Available
TI Information – Selective Disclosure
Camera 3 connector (ribbon cable)
• Camera 3 parallel data
• Camera 3 PCLK, Vsync, Hsync
• I2C #5
• LIN
TI Information – Selective Disclosure
Board-to-board connector (radar)
• Radar parallel data
TI Information – Selective Disclosure
Radar Rosenberger connector
Joern
“We had made error in the RF board Rosenberger pin
assignment(Serealizer board), now to correct it on our Deserializer
board we have connected connector on the bottom side of the
board.
So that Pin no1 would get mapped to 4 and Pin 2 would get
mapped to 3 and vice versa (In the Layout it will get mirrored).
Physically if you see the Layout and mapping of Joern (as shown
below left side) would map correctly to the Radar board.”
---Chethan Kumar
(4/16/2014)
926 EVM
Brian Shaffer
TI Information – Selective Disclosure
Back up slides
TI Information – Selective Disclosure
Deserializers for Camera 2 and Camera 3
• Need to align camera 2 and camera 3 components
TI Information – Selective Disclosure
Bottom view (4/8/2014)
TI Information – Selective Disclosure
Top view (4/8/2014)
TI Information – Selective Disclosure