6182-4P_sky terminator_IM
Instruction Manual for
Sky Terminator
Interactive Battling DroneTM
REMOTE BATTERY INSTALLATION
AGES
14 +
Make sure the power switch is in “OFF” position.
6. Do not use or leave battery near a heat source such as a fire or space heater;
exposure to heat may result in reduced performance or in some cases dangerous
conditions.
7. If battery is left in charging state for an extended period of time after being fully
charged, the battery may automatically discharge.
8. Never leave the battery unattended during charging.
1. Use a screwdriver to loosen the screw on the battery case.
2. Insert 4 ‘AA’ batteries in the compartment according to indicated polarity.
3. Replace the cover and tighten the screw.
battery
case
Thank you for your purchase of Protocol’s Sky Terminator Interactive Battling Drone. You are
about to experience the best of what remote control flight has to offer. We strongly recommend that
you take the time to read this manual thoroughly. It contains many tips and instructions on how to
get the most of this aircraft, and maintain it for long life.
As with any aircraft, this is a precision flying machine. Treat it well and enjoy all the fun it has to
offer, flight after flight.
PARTS
Speed Switch
Transmitter
Receiver
2. Take care to insert charging cable in
correct orientation as reversing the polarity
may lead to a malfunction.
Life Light
Power Switch
*Sky Terminator uses a 3.7V 220mAH Li Po Battery
Canopy (Top)
Rotor
Rotor Guard
Auto Manual
Mode Mode
OFF
Power
M
1. Do not immerse or submerge battery in water; store in a cool, dry location.
2. In order to increase battery longevity, avoid repeat charging and excessive discharging.
3. Charge battery to approximately 55% capacity prior to long-term storage.
4. If battery sees no use for extended periods of time, it is recommended that battery
voltage is kept above 3V. Check monthly and recharge as needed.
5. Do not disassemble battery.
1. If the Sky Terminator and the remote do not sync after following the Pre-Flight checklist,
reverse the first two steps of the process. Turn the remote off and unplug the cable from
the Sky Terminator. Then, turn on the remote first and then plug the cable back into the
Sky Terminator to turn it on. Follow with Step 3.
2. Turn on the controller; if, after 30 seconds, it has not recognized the helicopter, turn off
controller to retry synchronization.
3. If the Sky Terminator is unsteady in flight, it may not have been able to calibrate
horizontally; Power down both vehicle and remote and restart pre-flight procedure.
Canopy(Bottom)
Landing Gear
1. When charging, place product on a dry, well-ventilated surface and keep away from
heat sources.
2. Always use adult supervision while charging.
3. As battery temperature is high immediately after flight, charge after cooling down for
higher efficiency.
4. Do not strike or subject battery to hard impacts or sharp surfaces.
5. Do not use any other charger than that which is supplied with this item.
GROUND BASE
Battery Installation and Set Up:
Move the left stick to the right.
Turn
right
Move the left stick to the left.
The Sky Terminator features 3 speed modes. Low speed is at 40%, Medium is at 70%, and High
is at 100%. Choose the speed based on flight experience and level of comfort.
1. Using a Phillips screwdriver, open the battery compartment. Insert 3 ‘AA’ batteries
according to indicated polarities. Replace the battery cover.
2. Once you are ready for a battle, turn on the ground base and the drone. Fly the drone
around as described in the above sections.
3. There are 2 modes to use the base. Flip the base switch to ‘A’ to have it fire automatically.
Flip to ‘M’ to fire manulally by pressing the red button for each shot.
Move the right stick to the left.
Bank
left
Move the right stick to the right.
Move the right stick forward.
Move the left stick upward.
GO UP
FORWARD
MAINTENANCE
1. Clean the quad-copter with a clean, soft cloth.
2. Do not leave the quad-copter in the sun or a bright light.
3. Do not expose quad-copter or its electronic parts to moisture or water.
4. Regularly check connections and other parts.
5. If you find any defective part, stop flying until the repair.
PRE-FLIGHT
Once you are familiar with the basics of quad-copter flight, you can try some
advanced maneuvers! At a height of at least 10 feet, press the flip button and the
remote will continuously beep. Then move the right stick in whichever direction
desired to perform a 360-degree flip in that direction. After the flip, the Sky Terminator
will then restore to default status.
Front Flip
Step 3: Move throttle up and
then down. The LED light
on Sky Terminator will go
steady indicating it is synced.
Firing Button
Speed Switch
360°
flip
Move the left stick down.
Rear Flip
360°
flip
Thank you for your purchase of Protocol’s Sky Terminator Interactive Battling Drone. We
know that accidents can sometimes happen which is why we offer a spare parts kit available
on our website ProtocolNY.com.
Press and release to flip.
Left Flip
Right Flip
Step 2: Slide power
switch to “ON”
* The drone will turn after each of the first two hits.
The drone will flip after the third hit.
The drone will gently land
after 4 hits.
Replacement Parts:
360°
flip
Step 1: Plug the cable
into the socket on the
Sky Terminator and
place it on a flat surface
to allow calibration.
Battle:
1. Press the red button on the back of the base to start the battle.
2. The ground base will then fire at the drone.
3. The first side to get 4 direct hits wins. If the drone is hit 4 times, the motor will stop and it
will gently fall to the ground. If the ground base is hit 4 times, it will briefly stop firing.
Bank
right
Turn
left
HIGH, MEDIUM, & LOW SPEED MODES
Rotor Guard Support
Start / Stop
A
Unplug the charging cable from the aircraft canopy, connect this to the supplied USB
charging cable. Insert the USB end of the charging cable into the USB port of any computer
(or a USB port power adapter) to begin charging aircraft. The red LED indicator will be off
during charging and will go on when the charging cycle has completed. Once fully charged,
plug charging cable back into canopy. The aircraft is now powered on.
1. When using a computer USB port as power
source, remember to unplug the USB cable
prio to shutting down computer.
Direction stick
Indicator
Light
Charging the Quad-Copter’s On-Board Battery
40 minutes of charging yields 5-6 minutes of flight
Firing Button
Throttle
Stick
CHARGING
SKY TERMINATOR
NOTE
360°
flip
GO DOWN
Move the right stick backward.
BACK
Note: While fine-tuning flight characteristics, maintain constant position and altitude.
LIMITED WARRANTY
At Protocol, we’re dedicated to bringing you innovative and well-designed products that make
living fun and easy. We stand behind all of our products and warrant this to be free from
defects in workmanship and materials for 30 days from the date of purchase. The warranty
does not cover transportation damage, misuse, accident, or similar events. Specific legal
rights pertaining to this warranty may vary by state.
For service claims or questions please consult our website ProtocolNY.com.