Solid State Personal Communication Power Amplifier 7047 – PCM4Q5AGT 1805 - 1880MHz / 40 Watts W-CDMA/GSM HARRIS AMPLIFIER MODULE The PCM4Q5AGT (SKU7047-40) is suitable for Ultra linear SMR and iDEN repeater and base station applications in the Cellular frequency range. Also suitable for CDMA, GSM and TDMA applications, this amplifier utilizes linear LDMOS power devices that provide high gain, wide dynamic range, and excellent group delay and phase linearity. Exceptional performance, long term reliability, and high efficiency are achieved by employing advanced matching networks and combining techniques, EMI/RFI filters, machined housings, and qualified components. Empower RF’s ISO9001 Quality Assurance Program assures consistent performance and the highest reliability. Solid-state Pre-D linear design Small form factor and lightweight Suitable for SMR, iDEN and multi FA Applications. 50 ohm input/output impedance High reliability and ruggedness Built-in high dynamic range ALC circuit and control functions Built-in Output Circulator ELECTRICAL SPECIFICATIONS @ +28 VDC, 25°C, 50Ω System Parameter Symbol Operating Frequency BW Output Power CW PSAT Output Power @ 1 dB Gain Compression Point P1dB Power Output CDMA per IS-97 PWCDMA Gain at Rated POUT G Input Power Range with ALC ON PI N Small Signal Gain Flatness ∆G Gain Flatness @ 46 dBm, PIN = 0 dBm, (ALC ON) ∆GALC Input/Output Return Loss S11 / S22 Third Order Intercept Point IP3 2-Tones, POUT = 12 W Avg., ∆ = 500 KHz Harmonics @ P1 dB Gain Compression Point H Noise Figure NF Spurious Signals Spur Operating Voltage VDD Supply Current @ POUT = 40 W CW IDD Supply Current @ POUT = 12 W Composite IDD MECHANICAL SPECIFICATIONS Parameter Dimensions Weight RF Connectors In/Out DC / Function Connector Cooling Typ Ph. 1 (310) 412-8100 Fax. 1 (310) 412-9232 Max 1880 50 10 60 -12 -10 +62 7 26 Min 0 -40 63 +1 ±0.75 ±0.5 -14 +66 28 6.2 4.0 Value 5.5 x 4.6 x 1.0 2.0 SMA female D-sub, 9 Pins, Male External Heatsink ENVIRONMENTAL CHARACTERISTICS (Design to Meet) Parameter Symbol Operating Case Temperature Tc Storage Temperature Tstg Relative humidity (non-condensing) RH Altitude (MIL-STD-810F Method 500.4) ALT Shock / Vibration (MIL-STD-810F Method 516.5) SH / VI 316 W. Florence Ave. Inglewood, CA 90301 Min 1805 50 Typ Unit MHz Watt Watt Watt dB dBm dB dB dB dBm -45 10 -60 30 6.7 dBc dB dBc Volt Amp Amp Units Inch lb. Limits Max Max Max +75 +85 95 30,000 Unit °C °C % Feet Airborne www.EmpowerRF.com Stock No. 7047-40 D.S. Rev. 2.1 / 09-07-2011 Solid State Personal Communication Power Amplifier 7047 – PCM4Q5AGT 1805 - 1880MHz / 40 Watts W-CDMA/GSM PROTECTIONS Input Overdrive +6 dBm ∞ @ all load phase & amplitude for duration of 1 minute 3:1 @ all phase & amplitude continuous 85°C shutdown Load VSWR @ nominal output power Thermal Overload INTERFACE CONNECTOR D-Sub, 9-Pin Pin # Description 1 Forward Power Monitor 2 Reverse Power Monitor 3 ALC ON/OFF 4 ALC Level 5 Mute 6 7 8 9 +VDD +VDD GND GND Specifications Continuous Analog voltage relative to forward power via RMS detector FWDM: 27 – 47 dBm @ 0 – 5 V (100 mV/dB) Continuous Analog voltage relative to reflected power via RMS detector REVM: 24 – 44 dBm @ 0 – 5 V (100 mV/dB) ALC ON = TTL “High” ALC OFF = TTL “Low or Open” Continuous adjustable range via analog input levels Input Power Range: -12 dBm to +1 dBm Setting Point (ASP): 33 – 47 dBm @ 0 – 5 V (250 mV/dB) 46 dBm @ 4.75 V Error Range (AER): ±1.5 dB Response Time (ART): 100 mS/dB Amplifier Enable: TTL “Low” or Open Amplifier Disable: TTL “High” +28 ± 2 VDC +28 ± 2 VDC Ground Ground LED Indicator Output Power level indicator referenced to ALC setting (optional) LED 316 W. Florence Ave. Inglewood, CA 90301 Ph. 1 (310) 412-8100 Fax. 1 (310) 412-9232 www.EmpowerRF.com Max Nom Max Stock No. 7047-40 D.S. Rev. 2.1 / 09-07-2011 Solid State Personal Communication Power Amplifier 7047 – PCM4Q5AGT 1805 - 1880MHz / 40 Watts W-CDMA/GSM OUTLINE DRAWING 316 W. Florence Ave. Inglewood, CA 90301 Ph. 1 (310) 412-8100 Fax. 1 (310) 412-9232 www.EmpowerRF.com Stock No. 7047-40 D.S. Rev. 2.1 / 09-07-2011