Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T 07 3286 2299
F 07 3286 6599
E sales@lumascape.com.au
W www.lumascape.com.au
INSTALLATION INSTRUCTIONS
SPOTLIGHT & FLOODLIGHT
MODEL: LS452
INPUT VOLTAGE: 220-240 V AC, 50/60Hz
A.C.N. 0105 72 773
LS452: Centria Inground Gear Enclosure Direct Burial
Warranty void if not installed as per installation instructions
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
WARNINGS
FINISHED APPEARANCE
All connections must be kept dry;
failure to do so may result in product
reliability issues
Do not allow soil, mulch or foreign
material to build up around the
Luminaire
CAUTION: fixtures can become very
hot. Use discretion in placement
WARNING
1.
Install Luminaire
Ensure the luminaire is electrically
isolated and install in accordance with
local wiring rules.
2.
Remove Front Cover
Remove the front cover of the luminaire to get access to
the the lamp holder optical accessories.
NO DOWNWARD
FORCE
130 mm min
NO POWER
TOOLS
DO NOT
OVERTIGHTEN
Power supply must be isolated prior to
connection or disconnection of cables.
Failure to do so will result in damage
to the luminaire components.
3.
6.
Install Lamp
Remove the reflector to get access to the
lamp holder and install the appropriate lamp.
drainage
gravel
4.
Install Optical Accessories
After putting the reflector back over the lamp
install any optical accessories required
5.
Seal Luminaire
Re-seal the luminaire by putting the front
cover back into place.
Target Luminaire
Loosen grub screws and adjust tilt and rotation
of luminaire to the desired position. Re-tighten
grub screws once luminaire is aiming in the
desired direction.
www.lumascape.com.au Copyright ©2013 Lumascape Lighting Industries Pty. Ltd.
ABN 21 010 572 773
IN0121 - 17 September 2013
Do not allow soil, fill or any material to build up around the luminaire.
Warranty will be void.
Correct installation
Incorrect installation. Void warranty


SAFETY INSTRUCTIONS
WARNING - To reduce the risk of FIRE or INJURY:
1.
2.
3.
4.
5.
6.
Luminaires and transformers to be installed by licensed electrical contractors.
Luminaires to be used for intended purpose only.
Do not operate the luminaires with a missing or damaged parts.
Use only genuine Lumascape parts to replace damaged or missing components.
Refer to instructions for installation and operating requirements.
Ensure installation complies with local regulations
Voltage insulation test (megger) will permanently damage product and will void warranty.
SAVE THESE INSTRUCTIONS.
Questions?
Call +61 7 3286 2299
Email sales@lumascape.com.au
www.lumascape.com.au
www.lumascape.com.au Copyright ©2013 Lumascape Lighting Industries Pty. Ltd.
ABN 21 010 572 773
IN0121 - 17 September 2013