Housing units
Simplify and save
Cut ordering time and shipping costs with SKF Housing Kits
Researching and ordering all of the component parts that
comprise a housing unit is a costly, time-consuming and
unnecessary process. Just place a single SKF Housing Kit
order and receive one package containing a high-quality SKF
Explorer bearing, housing and all of the components needed
to create a high performing bearing system. We match all the
components so you do not have to, and you get the convenience of a complete solution with the reliability and service life
of SKF components.
SKF Housing Kit component highlights:
SKF Explorer spherical roller bearing
•High load carrying capacity – both radially and axially
•Highly wear-resistant bearing material
•High running accuracy
•Low friction
SKF plummer block housing
•SE or SNL housing depending on size
SKF Housing Kits offer:
•According to ISO 113
✓✓Time savings
✓✓Single order line
•Simple mounting and dismounting
✓✓Easier ordering
✓✓Increased availability
•Robust housing with good head dissipation
✓✓Cost savings
✓✓Reduced inventory
•Efficient grease guiding system
SKF housing seals
•The kit contains a complete set of housing seals and an end
cover in case the housing should be placed at the end of the
shaft
•Kits are available with either four-lip or V-ring seals
SKF Housing Kit contents:
✓✓Spherical roller
bearing
✓✓Plummer block
housing
✓✓Locating rings
✓✓Housing seals
✓✓End cover
For kits including bearings with tapered bore, an
adapter sleeve complete with a lock nut and lock
washer is included.
The Power of Knowledge Engineering
Designation system for SKF Housing Kits
The complete SKF Housing Kit designation identifies housing type, bearing type and seal. Prefixes and suffixes identify housing
and seal types respectively. When multiple suffixes are used, they are listed in the same order as shown below.
SE 22513 TL
Series Prefix
SE
Standard SE plummer block housings
SNL
Standard SNL plummer block housings
Size Identification
222(00)
Kit including a spherical roller bearing with cylindrical bore, diameter series 2 1)
223(00)
Kit including a spherical roller bearing with cylindrical bore, diameter series 3 1)
225(00)
Kit including a spherical roller bearing with tapered bore, diameter series 2 and an adapter sleeve 1)
226(00)
Kit including a spherical roller bearing with tapered bore, diameter series 3 and an adapter sleeve 1)
(00)
Size code of the bearing . (00) x 5 = bearing bore diameter (mm)
Suffixes 2)
TL
TA
/C3
1)
2)
3)
Four-lip seal 3)
V-ring seal 3)
Bearing with radial clearance greater than normal
SKF Explorer E-design bearing
When multiple suffixes are used, they are listed in the same order as shown here
Two seals, locating rings and end cover will be part of kit as default
For more technical and dimensional details, visit skf.com or see SKF bearing housings and roller bearing units catalogue (Pub. No: 13186).
skf.com | skf.com/housingkits
® SKF and SKF Explorer are registered trademarks of the SKF Group.
© SKF Group 2015
The contents of this publication are the copyright of the publisher and may not be reproduced (even
extracts) unless prior written permission is granted. Every care has been taken to ensure the accuracy
of the information contained in this publication but no liability can be accepted for any loss or damage
whether direct, indirect or consequential arising out of the use of the information contained herein.
PUB BU/P8 15533 EN · February 2015
Certain image(s) used under license from Shutterstock.com