1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421
Instructions
Tabbed Cone Panel
Figure 1
Assembly Steps
1. Lay cone panels on the ground as shown in Figure 1.
2. Slip four (4) cone panels together using tab and slot connections on edges of each panel.
(Please note that all tabs must be on the inside of the cone assembly.)
3. Place bolts through holes and thread nuts into place to hold four (4) cone panels together. (Nuts must
be located on the outside of the cone assembly.) (Do not tighten nuts.) (See Figure 2 on Page 2.)
4. Once four (4) cone panels are assembled stand assembly up on large radius side. (See Figure 1.)
5. Pull both ends together creating a heart shape as shown in Figure 2 on Page 2.
6. Place remaining bolts through holes and thread remaining nuts into place to hold cone together.
(Nuts must be located on the outside of the cone assembly.) (Do not tighten nuts.)
(See Figure 2 on Page 2.)
7. Install assembled cone onto fan unit using mounting brackets provided. (See Figure 3 on Page 2.)
(Make sure bottom panel with drain hole is closest to the ground.)
8. Install butterfly assembly into cone. (The butterfly assembly is bi-directional and DOES NOT have a
top or bottom.) (Not shown.)
9. Tighten all cone and butterfly hardware.
Date: 06-11-09
Printed in the U.S.A.
Copyright © 2009 by
www.gsiag.com
PNEG-1701
Page 1 of 2
Group
PNEG-1701
Tabbed Cone Panel
Nuts on outside of
cone assembly
Figure 2
Figure 3
Page 2 of 2
PNEG-1701