Holders Iris Diaphragm IDC/IH-30N Catalog Code W4040 An iris diaphragm is used to adjust an aperture without changing the center of the aperture. Primarily used in the limited spaces of optical instruments to set an aperture size. Application Systems Optics & Optical Coatings ◦Bare, unmounted iris diaphragms are ideal for applications where mounted irises are too large or otherwise not appropriate. ◦The IDC series has a thin body, which allows placement of optics in proximity to the front and back of the iris diaphragm. ◦Various aperture sizes are available to suit the usage. ◦The adjustment lever also functions as a clamp to fix the aperture diameter. Guide Holders ▶Iris diaphragm holders (IH-30/IH-R) which can be fixed to the post C061 holder are also available. ▶Fixed pinholes (PA) with hole diameter 400μm or less are also available. C059 Bases Manual Stages Attention ▶Aperture diameter can be changed by moving the adjustment lever lightly. The adjustment lever can break if pressed with excessive force exceeding the adjustment range, or pressed on the wrong direction. Handle with care. ▶The iris diaphragm is a very delicate mechanism. Do not push or pull on the blades. ▶The iris diaphragm consists of thin metal blades. Heat from highpower lasers may deform the blades and cause them to seize. Not recommended for use with high-power lasers. (recommended max power: CW 500mW or less, pulse 30mJ or less) ▶The iris diaphragm does not have a scale. Use the iris diaphragm holder when a scale is needed. Actuators Motoeized Stages Light Sources Index Outline Drawing Lasers Beam Shaping Diffusers S Iris diaphragm side φ30 Polarizers Iris diaphragm side Adjustment lever M34 P0.75 0 φA −0.05 Prisms 2.6 Adjustment lever Aperture diameter MAX L 12.6 φ50 Lenses 6 φ4 9.5 T φ32 Mirrors IH-30N φ30 IDC Aperture diameter MIN Guide 2.4 Filters Shutter Others Fiber φA [mm] T [mm] L [mm] S [mm] IDC-000 φ14.8 4.5 11 1.30 IDC-001 φ19.8 5 11 1.25 IDC-003 φ24 5 11 1.45 IDC-009 φ33 5.5 11 1.43 IDC-017 φ50 6 15 1.60 IDC-025 φ70 7.5 15 2.05 Part Number φ8 − φ50 Part Number C062 Primary material: Aluminum Finish: Black Anodized Aperture Diameter MAX MIN [mm] [mm] Number of Blades [blades] φ30 Primary material: Aluminum Finish: Black Anodized Weight [kg] Part Number Aperture Diameter MAX MIN [mm] [mm] IH-30N φ30 IDC-000 φ8 φ0.7 9 0.003 IDC-001 φ12 φ0.8 11 0.005 IDC-003 φ15 φ0.9 12 0.007 IDC-009 φ22 φ0.9 14 0.012 IDC-017 φ36 φ1.3 16 0.024 IDC-025 φ50 φ1.5 16 0.062 φ1 Number of Blades [blades] Weight [kg] 10 0.03