Installation Guide
GE
Lighting
Lumination Suspension Kit
TM
(SS Series)
Components
Non-power Feed Kit
Power Feed Kit
BB-1420
Bracket Bar w/ 1/4-20
Stud & Ground Screw
2” White Canopy
CC-1420-T2
Ø5” White Canopy with
2 Power feed Holes
CC-18IP-SR
Slip Ring Cable Coupler
White Heyco Strain
Relief Bushings
1/16” Galv. Cable
1/16” Galv. Cable
14/4 ST Cord
600V 105C
Prepped One End
ZF-15Z-XC
Cable gripper
1/16” Galv. Cross
Cable w/ Toggle Ends
18/2 SVT Cord
White with Grey & Violet
Conductors
Prepped One End
ZF15-15Z-XC
Cross Cable Gripper
1/16” Galv. Cross
Cable w/ Toggle Ends
White Heyco Strain
Relief Bushings
imagination at work
Installation
Junction box
in ceiling
Dimming line
Stud
Cable
coupler
5-inch
powerfeed
canopy
AC line
Slip ring
Crossbar
1
Attach crossbar to junction box in ceiling with two
#8 screws (not provided).
2
Pass cable through cable coupler and screw onto
stud. Pass cable through canopy and slip ring
(power canopy shown).
Down cable
Cross cable gripper
2-inch non-power
feed canopy
Toggle cable
Cable
coupler
2nd cable
3
Hang second cable to a structural ceiling member
capable of supporting 44 pounds and cover with
non-power feed canopy.
4
Assemble cross cables: Remove screw from cross
cable gripper and insert toggle cable into slot.
Replace screw and tighten.
Press tip
to adjust
5
Insert both ends of the toggle cable into the
luminaire mounting holes and adjust so that the
toggles are engaged and will not come out of the
holes when loaded.
6
To adjust height and to level a fixture, press the
tip of the gripper and pull the suspension cable
to the desired height. Clip the cable with cable
cutters to finish the appearance.
NOTE: Gripper cannot be depressed while there
is weight on mechanisms.
Dimming
wires
Strain relief
bushings
AC wires
Dimming
wires
AC wires
Strain relief
bushings
7
Remove electrical cover and install cords using
provided strain relief bushings. Connect the black
(line), white (neutral) and green (ground) wires from
the luminaire to the matching-­colored wires of the
AC cord. Connect the white/grey and violet wires
from the luminaire to the matching-­colored wires of
the dimming cord.
8
Connect the black (line) and white (neutral) wires
from the ceiling to the matching-­colored wires
from the AC cord. Connect both green wires to the
grounding screw. Connect the white/grey and violet
wires from the luminaire to the matching-­colored
wires from the dimming circuit.
NOTE: A brown wire in the through wiring is offered
for an additional circuit as needed.
Zip tie
Slip ring
9
Push canopy up to ceiling and tighten slip ring over
cable coupler. Make sure no openings are present in
enclosure.
10 Secure feed cords to aircraft cable using provided
zip ties.
Conforms to the following standards:
GE Lighting • 1-888-MY-GE-LED
(1-888-69-43-533)
• www.gelighting.com
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand, logo and Lumination are trademarks of the General Electric Company.
© 2015 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
IND189-050115