For simplicity, I have arbitrarily assigned the pin numbers for the plug. Looking at the
back of the plug where the wires come in, start at the first pin and count left to right.
Speedo Harness
#1…56B-18…to turn signal switch, to 56A-18, to terminal A on front harness connector,
to left turn signal
#2…42-18…to JJ terminal on engine harness connector, to 42-16, to 4WD indicator
light switch
#3…52A-18…to a connector, then 51-16 out of that connector to the light switch
#4…57B-18…to turn signal switch, to 57A-18, to B terminal on front harness to right
turn signal
#5…62G-18…to panel light connector, to 62F-16, to shift indicator light (optional)
#6…Blank
#7…44A-18…to G2 on Ignition switch, to radio feed 44B-18, to G terminal on front
harness connector, to 44B-18 to brake pressure switch
#8…44-18…to I terminal on ignition switch, to 16-18, to FF terminal on engine harness,
to 16-16, to positive side of coil
#1
#2
#3
56B-18
LF TRN
Signal light
42-18
4WD IND
Switch
#4
57B-18
RT TRN
Signal light
#6
#7
44A-18
Brake
Pressure
Switch
52A-18
To light
switch
#5
62G-18
Shift Ind
light (if
equipped)
#8
44-18
Positive
side of Coil
Blank
Fuel Gauge Plug
#1…Blank
#2…62D-18…to Panel Light Connector, to 62E-18, to knob light ground
#3…Blank
#4…Blank
#5…11B-18…Ground
#6…36-18…to S terminal on Rear Harness Connector, to 36-16, to fuel sending unit
#7…28B-18…to #7 pin on Oil Pressure plug. (Piggy back power feed)
#8…Blank
#1
#2
62D-18
Panel lights
knob ground
Blank
#3
#4
#5
Blank
Blank
11B-18
Ground
#6
#7
28B-18
Piggy back
power feed
from oil
pressure
plug
#8
36-18
Fuel
Sending Unit
Blank
Oil Pressure Plug
#2…62B-18…to Panel Light Connector, to 62C-18 heater ground
#3…28A-18…to A terminal on Ignition Switch to fuse block (power feed)
#4…Blank
#5…11C-18…Ground
#6…35-18…to AA terminal Engine Harness Connector, to 35-16, to Oil Pressure
Sender
#7…28B-18…to #7 terminal on Fuel Gauge plug
#8…29-18…to BB terminal on Engine Harness Connector, to 29-16, to Water Temp
Sending Unit
#1
#2
62B-18
Panel light
Connector
Blank
#3
28A-18
To Ignition
Switch (Hot)
#4
#6
35-18
Oil Pressure
Sending Unit
#7
28B-18
Power from
Fuel Gauge
#5
11C-18
Blank
Ground
#8
29-18
Water Temp
Sending Unit
This information came straight out of the Scout II service manual. Your harness may
vary, so check and verify.