Banner Browser
Assembly Instructions
Customer
Support
effective 12/9/11
The following are the materials necessary for assembling your banner browser. Please verify that all of
these parts are enclosed. If you are missing any parts or have difficulty assembling your browser call
InScribe Customer Support at 800-346-3461.
(1) pole with a hole
in its side (Pole A)
(1) base
(4) wheels
(1) spine
(8) banners
(4) wings
(1) pin
1. Place the narrow end of Pole A into
the base. See Figure 1. If necessary,
use a rubber mallet on the top of the
pole to assure that the pole is
straight and snug in the base.
2. Turn the pole and base on its side.
Insert the four wheels into the holes
on the bottom of the base.
Individually adjust each wheel so
that the base sits level by turning
the nut. See Figure 2.
3. Insert the pin into the hole in Pole
A. If necessary, loosen or tighten the
pin with pliers until it fits snugly
around the pole. See Figure 3.
(8) nuts
(1) pole without a hole (Pole B)
(1) ring with
ball bearings
(2) plain
rings
(4) banner guards
Figure 2
Figure 1
nut
hole
base
Figure 3
9 Micro Drive, Woburn, MA 01801-5701 tel: 781 • 933 • 3331 fax: 781 • 932 • 3331
www.inscribe.com
207m
4. Place a plain ring around the pole,
sliding it down until it sits on the
pin. Then put the ring with ball
bearings around the pole, sliding
it down until it sits on the plain
ring. Next place another plain ring
around the pole, sliding it down
until it sits on the ring with ball
bearings. See Figure 4.
Figure 4
Figure 5
plain ring
ring with ball
bearings
plain ring
pin
5. Insert the narrow end of Pole B into
the top of Pole A.
6. Tilt the poles and base, then slide the spine onto the poles so that
the wider end rests on the top ring. See Figure 5.
Figure 6
7. Each side of the spine has four holes. Place the bolts on the bottom
of the banner guard into the two leftmost holes. See Figure 6.
Tighten nuts onto the bottom of each bolt so that the banner guard
is securely in place. Repeat for each side of the spine.
8. Each banner has a loop at the top and a removable loop attached
by velcro at the bottom. Slide the top loop over one of the top
crosspieces on the wing. See Figures 7 and 8. Be sure to place
banner so that the text faces out.
9. Detach the removable loop from the bottom of the banner and slide
it over the bottom crosspiece on the wing so that the velcro is facing
out. See Figure 9.
Figure 7
Figure 9
Figure 8
top crosspieces
top pin
bottom pin
bottom
crosspieces
10. Use the velcro to attach the bottom of the banner to the removable loop so that the banner is taut
on the wing.
11. Repeat steps 8 - 10 for each remaining banner. Each wing should hold two banners back to back.
Refer to the enclosed banner planagram to ensure that the banners are in the correct order.
12. Insert the top pin of one of the wings into the rightmost hole at the top of the spine. See Figures 8
and 10.
13. Insert the bottom pin on a wing into the rightmost hole on the bottom of the spine, so that the wing
is between the banner guard and the round guard on the base of the spine. See Figures 8 and 11.
14. Repeat steps 12 and 13 for the three remaining wings. Display should look like Figure 12 when
finished.
Figure 10
Figure 11
Figure 12
round guard
banner guard