Applying Strut/Hinge Assembly – Fig. 2
•
(A) Align lateral hinge assembly along border of the
leg with the hinge centered slightly above to joint
line. Struts should run along midline of thigh and
lower leg.
NOTE: Ensure cuffs align with foam straps and secure
assembly onto foam straps. Adjust as needed.
POST-OP COOL
ADJUSTABLE KNEE BRACE
•
•
Foam Band Placement – Fig. 1
•
•
Remove foam bands from hinge assembly.
Apply foam bands onto leg comfortably yet
snug. From the knee, bands should be placed
approximately as shown in Figure 1.
(B) If struts need to be lengthened, press button and
pull cuff to extend. Ensure the cuffs “snap” into a
locked position for secure placement.
Repeat steps with medial assembly along opposite
side of leg.
Hinge Adjustment – Fig. 3
•
•
•
(A) Rotate center dial to UNLOCK position ( )
position.
(B) Slide ROM dials to corresponding flexion/
extension positions.
(C) Rotate center dial to LOCK ( ) position to
ensure secure ROM fixation.
NOTE: Hinge assembly comes with a center LOCK/
UNLOCK dial to prevent unintended changes to the
range of motion settings when in use. The UNLOCK
position is only for use when adjusting dial.
NOTE: Both medial and lateral hinge assemblies can be
simultaneously mounted if desired.
)A(
B
(C)
Slide
(B)
Slide
(B)
Fig. 3
5”
Drop Lock Adjustment – Fig. 4
•
4”
4”
Drop lock can be engaged at 0˚, 15˚, 30˚, 45˚ at any
time by patient, regardless whether center dial is in
LOCK or UNLOCK positions.
B
Lock
Unlock
5”
Fig. 2
Straps/Fasteners
•
Fig. 1
D06-00D02_REV00
Apply straps and fasteners. First fasten 2 straps
closest to knee to act as locators to ensure proper
fitment. Fasten remaining 2 straps. Adjust tension
and fastener locations in accordance to patient
needs and comfort.
NOTE: Educate patient on brace adjustment, removal,
and application if needed.
45
Fig. 4
30
15
0
0, 15, 30, 45
Caution: In the event of discomfort or numbness of any
kind relating to the use of this product, consult your
physicain immediately.