510YC25ARTG2S
500 Series - Surge Protective Device
The Emerson Network Power 510 is a multi-phase, multi-mode surge protector, which
incorporates the same fuse/surge array design philosophy as the 570 and 560 products. A
coordinated, multi-component/multi-fuse approach is the key to addressing even the
harshest conditions. With a short circuit rating of 200kAIC, a UL 1449 Type 1 rating, along
with a myriad of enclosure and surge levels; the 510 can be placed on any panel within your
facility, making it the ideal choice for cascaded applications.
Technical Specifications
Nominal Operating Voltage &
Phase Configuration
Operating Voltage Range
Operating Frequency Range
ANSI/IEEE C62.41 Category
Connection Type
Capacity
Size
Enclosure Rating
Weight
Modes Of Protection
277/480VAC, Three Phase Wye, 4 Wire + Gnd
50W EMI/RFI Max Attenuation
SPD Monitoring Option
Response Time
Operating Temperature
Operating Humidity
Warranty
Certifications
Maximum Surge Current Capacity (8 x 20 ms)
Line to Neutral
Line to Ground
Line to Line
Neutral to Ground
Per Phase
Total
277 VAC +/- 15%
47 - 63 Hz
A, B, & C
Rotary Disconnect (#8 - 1/0 AWG), Neut/Gnd (#14#2)
Continuous (Parallel Connection)
20" [508] x 16" [406] x 8" [203]
NEMA 4, 12, 13 Steel - Indoor/Outdoor rated
56 lbs. (25.4 kgs.)
L-N, L-G, L-L, N-G (All Mode)
63 db max from 10 kHz to 100MHz; The system
provides up to 120dB insertion loss from 100 kHz to
100 MHz when used in a coordinated facility
Advanced Transient Detection System
Web-Based Power Quality Monitor
* monitoring system specifications on page 2
<.5 nanoseconds
- 40°C to 60°C
0% to 95% Non-Condensing
10 Years Parts
UL 1449 Third Edition (2009)
CUL & UL1283
250kA Per Mode / 500kA Per Phase
250kA (250,000 Amps)
250kA (250,000 Amps)
250kA (250,000 Amps)
250kA (250,000 Amps)
500kA (500,000 Amps)
1750kA (1,750,000 Amps)
Features
250kA Per Mode / 500kA Per Phase
Redundant Modular Design
Indoor/Outdoor Rated Enclosures
IEEE Life Cycle Tested
Integrated Web-Based Power
Quality Monitor
ANSI/IEEE C62.41 Specifications
Endurance/Life Cycle Testing
Tested to 24,000 Impulses
Per Mode without degradation
Cat C3 Combination Wave
UL1449 Specifications
Fault Current Rating
UL1449 SPD Location Type
UL1449 Nominal Discharge Current (In)
Maximum Continuous Operating Voltage (MCOV)
L-L / L-N / L-G / N-G
UL 1449 Third Edition - Voltage Protection Ratings - VPR's
Line to Neutral
Line to Ground
Line to Line
Neutral to Ground
200kAIC
UL1449 Type 2
20kA
640V / 320V / 320V / 320V
1200 Vpk
1200 Vpk
2000 Vpk
1000 Vpk
page
1 of 2
Line to Neutral: 1160 Vpk
1160 Vpk
Line to Ground: 1800 Vpk
1360 Vpk
Cat C1/B3 Combination Wave
Line to Neutral: 840 Vpk
840 Vpk
Line to Ground: 1500 Vpk
860 Vpk
Advanced Transient Detection System
Emerson Network Power Surge Protection makes it easy to monitor your electrical system by integrating its advanced Transient
Detection System and monitoring package within its SPDs. The web-based device allows the end-user real time power quality
measurements, logged events, statistical summaries and premium power protection. Understanding the severity, type and
timing of the event allows you to analyze trends and ultimately better manage your electrical system.
Technical Specifications
Voltage
Accuracy
Range
Average, Unbalance, Crest Factor
Frequency
Accuracy
Range
VTHD
Range
Harmonics
Range
RMS
SPD Health Status
I/O
Relay Outputs
RJ-45 Port
Terminals (#24-#14)
Events
Event Logging
Surge, Sag, Swell, Phase Loss/Outage, Overvoltage,
Temporary Overvoltage (TOV), Voltage Interruption/Dropout,
Neutral Bond, Voltage Harmonics (VTHD), Over/Under
Frequency, Protection Failure
Date/Time Stamp with Duration/Magnitude
Surge Counter, Sag Counter, Swell Counter, w/ reset
Display
Communications
Embedded Webpage
Phase A, B, & C
± 1%
0-600V
Standard
Standard
± 1%
45-67 Hz
Line-to-Neutral, Line-to-Line
850Hz
Line-to-Neutral, Line-to-Line
Fundamental – 13th
± 1%
Percent Remaining
Standard
1: 2 Form-C
Ethernet
RS-485 Communication
Power Quality & System
8GB / 1000+ Events
Standard
Standard - All events
Standard
LCD 128x64
RS-485, MODBUS TCP/RTU,
Ethernet, SNMP, SMTP, Form C
Standard
Features
Power Quality – Ability to monitor
voltage at every connected panel and
track system anomalies such as
transients, surges, swells and VTHDs.
Real Time Measurements – Allows
over 1000 events/reports to be stored
for future analysis
Event Logging – User configurable
alarm thresholds, time/date stamp,
duration and magnitude of events.
Communications – Information easily
accessed through the Ethernet or
MODBUS TCP/RTU communications
systems
Embedded Web Page - Convenient
access to present and past data right
at the device.
System Analysis – Manage power
system with statistical summaries and
reporting software.
LCD Display – with capacitive touch
buttons for navigation.
Embedded Webpage
Real-Time Monitoring of Voltages,
Power Quality Events Measured and
Manage Your System with User Configurable
Event Counts and SPD Health Status
Recorded in Detail
Thresholds and Power Quality Reporting
Emerson Network Power Contact information
www.EmersonNetworkPower.com/Surge
Surge Protection
100 Emerson Parkway
Binghamton, NY 13905
T: (607) 721-8840
T: (800) 288-6169
F: (607) 722-8713
E: SurgeTech@Emerson.com
Emerson Network Power, the Emerson Network Power logo and Edco are trademarks
and service marks of Emerson Electric Co. ©2014 Emerson Electric Co.
While every precaution has been taken to ensure accuracy and completeness herein, Emerson Network Power Surge Protection assumes no responsibility, and disclaims all liability, for damages resulting from use of this information or for any
errors or omissions. Specifications are subject to change without notice.
page
2 of 2
Rev. 1/15