Storage Chokes

advertisement
Storage Chokes
DSH
and
DSHP
Series, vertical housing
Nominal current:
Nominal inductance:
Max. working voltage:
Application range:
Isolations voltage:
Climatic category:
Plastic case:
Potting resin:
0.45 - 6.3 A @ ϑa 70°C
12 - 2000 µH/ tol. ± 15%
600 VDC
up to 1 MHz
2 kV eff. / wdg.-ambient
40/125/21 acc. to IEC 60068-1
UL 94 V-0
UL 94 V-0
This range of chokes enable vertical mounting, thus reducing the
area of the PC board used. Finest quality core materials allow the
highest electrical performance with minimum component volume.
Good design with easy assembly allows good cost/performance ratio. This type of choke is essential in the field of power electronics,
e.g. switching power supplies, chopper amplifiers, DC drives and stepper motor controls.
DSH
Storage chokes, used as energy stores in switch mode
DSHP power supplies. Principle features:
Technical Data
The DSH choke can only be used with high frequency alternating
current or with HF-modulated direct current up to 1 MHz, under
consideration of their self heating (IN and DI at f0) and the ambient
temperature (ϑa).
Type
IN (1)
[A]
DSHP-6148-D6D1
0.6
DSH-14-0001
DSH-14-0002
DSH-14-0003
DSH-22-0001
DSH-22-0002
DSH-22-0003
DSH-22-0004
DSH-22-0005
DSH-22-0006
DSH-22-0008
DSH-31-0001
DSH-31-0002
DSH-31-0004
DSH-31-0005
0.6
1.0
2.0
0.45
0.63
1.0
1.4
1.8
3.15
6.3
1.6
2.0
4.0
6.3
LN (2)
Rcu (3)
100
550
140
50
12
2000
1000
400
200
120
40
10
500
300
100
35
280
100
25
1250
750
300
160
90
33
8
240
140
40
15
[µH]
(1) @ ϑa 70°C; current derating 70°C: I = IN x
[mΩ]
~ fRes
Case
[MHz]
11
48-1
8
12
35
0.4
1.8
3
4.8
6.5
14
35
2.5
3.5
6.5
13
01-1
01-1
01-1
09-1
09-1
09-1
09-1
09-1
09-1
09-1
19-1
19-1
19-1
19-1
- reduced magnetic reversal
- constant inductance at high alternating field modulation
and high DC magnetisation.
Environmental Ratings:
Typical
Ambient temperature
Operating frequency
Nominal DC current
HF-Ripple
ϑa
f0
IN
DI
=
=
=
=
70°C
50 kHz
as per table
20% IN
SMD-version upon request.
Application
(125-ϑa)/55
(2) Nominal inductance measured according to EN 138100,
see introduction of this catalog, paragraph 3.4
(3) Resistance @ ϑa 25°C
Case 48-1
Case 01-1,
Typical curve
09-1,
19-1
35
Download