RGB Slinky IP67
24v colour changing LED strip
Product notes
Energy efficient LED linear strip light which can create a variety of colour and colour changing effects. Suitable for general
effect low heat shelf lighting and for cornice lighting.
Colour Temperature
Lumens max
Wattage
RGB
435Lm/m
18W/m
Lifetime (70% Light output ratio)
50,000Hrs
Input
24vDC
Wiring
Parallel
IP rating
IP67
LED Technical information
RGB
1m min order lengths
11
4.5
Using the latest state of the art LED's, the LED has excellent colour rendition with a colour temperature that replicates
tungsten halogen. The LED is binned to 3 step Macadam Ellipse to ensure consistency when specified with multiple
products. John Cullen continually research the latest available solution as technology develops.
Product codes
P5369001m
Drivers
DR20
DR25
DR60
DR75
DR100
20w 24vDC
25w 24vDC
60w 24vDC
75w 24vDC
100w 24vDC
RGB Dimming interface
OTEASY 24vDC Colour changing kit include IR reciever, driver and remote control.
SPOS002 Dali controller
Y540100 DMX controller
F22RGBDI seperate 0-10v channels x 3
Installation notes
1Connection - Find a suitable accessible place for driver. Feed cable to required location.
2Installation - Specify correct length for proposed installation. Connect power supply to required driver to power
specified length. Connect 24vDC output to product. Can be cut on site every 100mm. Must be attached to a heatsink.
Correct polarity must be observed.
3 Qualified electrician – All electrical works to be carried out by a qualified electrician.
4 Cable thickness – Is the responsibility of the installer. Cable thickness must be calculated to avoid voltage drop.
Calculations and cable tables can be found within the latest edition of the IEE wiring regulations.
5 LED lamps in hot environments - LED lamps should be positioned away from heat sources such as heaters, under
floor heating, saunas etc. LED’s will prematurely expire if in sustained contact to heat.
6 Dimming Interfaces - Various control interfaces are available to control the RGB system. When wiring to a 0-10v
supply 3 x 0-10v cables are required. DMX and Dali controls are available please call for details.
7Drivers - Driver to be specified subject to installation requirements. Electrician to find discreet, accessible location for
remote drivers. Calculating cable lengths and diameter to avoid voltage drop is the responsibility of the installer. For
maximum distances please refer to specific driver specification sheet.
8 Cutting length - When an installation requires a specific length the product can be cut on site but only as detailed
using a sharp knife or pair of scissors. Cutting points are clearly marked. Cut only at indicated marks. Maximum length
possible 4 metres.
9 Linear LED lamps - Handle with care. Do not bend through 90 degrees as this will damage the LEDs. Lamp life 50,000
hours.
10 Heat sink - The product always requires a form of heat sink. JC recommends that aluminium heat sink tape or the
aluminium profiles (see accessories) are used on every installation and even on installations with an existing heat sink
i.e. an aluminium surface.
11 Polarity - The product must be connected with the correct polarity (black cable -ve, red cable +ve). Incorrect wiring will
damage the product, JC will not take responsibility. Please see wiring schematics for further information.
12 LED colour shift - Please be aware that all LED’s will appear to have a slight colour shift when located in close
proximity to each other and when placed in stark white installations.
PLEASE NOTE:-These notes are for guidance only. John Cullen accepts no responsibility for any installation using the
above notes and the final decision on installation remains with the installer.
SALES: 020 7371 9000
1137250113©
DESIGN: 020 7371 5400
www.johncullenlighting.co.uk