Component acceptance in end products
The following criteria would be applied by Eurofins for acceptance of components in the end product
submitted to Eurofins for national certification based on CB Test Certificates and CB Test Reports:
1
2
3
4
Information declared by Eurofins in the Component Matrix on the IECEE website.
Documentation of the safety of a component by:
a. CB Test certificate with Test Report
b. National certificate (e.g. GS) with or without test report
c. Test report
d. Eurofins is prepared to test components without such documentation as part of the
end-product application to the applicable component and end-product requirements
Compliance with declared National Differences in the respective European/German endproduct and component standards
(if applicable) GS-Certification requires the surveillance of production quality like factory
inspections etc.;
Surveillance of the component will be performed together with the end-product; this is valid for
the voluntary GS-certification regulated by law
Component acceptance policy.doc