25CAULK
COLOR MATCHED CAULKING
FOR .040/.060 WALL COVERING AND WALL PANELS
NOTE: MATERIAL MUST REACH 65° MIN. TO 75° MAX. 24 HOURS PRIOR TO INSTALLATION.
1.
APPLY THE ADHESIVE AS DESCRIBED IN THE WALL COVERING INSTALLATION INSTRUCTIONS. ALLOW THE
ADHESIVE TO CURE PROPERLY. (APPLIES TO ACROVYN WALL COVERING ONLY; PANEL ADHESIVE SHOULD
BE APPLIED TO THE WALL PANEL AND INSTALLED WHILE STILL WET.)
2.
INSTALL THE ACROVYN WALL COVERING PER THE INSTALLATION INSTRUCTIONS USING A SPACER NOT
LESS THAN 1/16" THICK TO MAINTAIN AN EVEN JOINT WIDTH.
3.
APPLY STRIPS OF MASKING TAPE ON EACH SIDE OF THE JOINT TO PREVENT EXCESS CAULKING FROM
GETTING ON THE WALL COVERING.
ADHESIVE
MASKING
TAPE
SPACER
ACROVYN WALL
COVERING
Doc #: II-25CAULK
Issue Date: 11/25/09
Rev Date: 11/16/11
25CAULK
COLOR MATCHED CAULKING
4.
APPLY ONE 1/8" BEAD OF COLORFLEX II CAULK TO THE WALL COVERING JOINT. BE CERTAIN THAT
A SUFFICIENT AMOUNT IS APPLIED AND THE JOINT IS FILLED WITH CAULK. COVERAGE EQUALS
90'-100' PER TUBE.
5.
SCREED OFF THE EXCESS CAULKING IMMEDIATELY SO IT IS FLUSH WITH THE SURFACE OF THE
WALL COVERING.
6.
REMOVE THE MASKING TAPE FROM BOTH SIDES OF THE JOINT.
NOTE: EXCESS CAULKING ON THE WALL COVERING SHOULD BE REMOVED AS SOON AS POSSIBLE
WITH WARM WATER AND A CLEAN CLOTH.
NOTE: USE STANDARD COLORFLEX II CAULK IF A SECOND COAT IS REQUIRED. PLEASE FOLLOW THE
SAME INSTALLATION PROCEDURE WHEN APPLYING THE SECOND COAT. ALLOW A MINIMUM OF FOUR
HOURS TO CURE BEFORE APPLYING THE SECOND TOP COAT.
CAULK
PUTTY
KNIFE
Muncy, Pennsylvania ● (800) 233-8493 ● Fax (570) 546-5169
Mississauga Ontario ● (888) 895-8955 ● Fax (905) 274-6241
www.c-sgroup.com ● iwptechsupport@c-sgroup.com
This document is the property of Construction Specialties, Inc. and contains CONFIDENTIAL PROPRIETARY INFORMATION
that is not to be disclosed to third parties and is not to be used without approval in writing from Construction Specialties, Inc.
Doc #: II-25CAULK
Issue Date: 11/25/09
Rev Date: 11/16/11