tnb06_wrtrm_secc_p48_49
8/9/07
11:40 AM
Page C-48
Mechanical
Mechanical
Parallel Groove Connectors
Easy to install — no special tools required.
Type PC — Two-Bolt Parallel
Groove Clamp
• Made of high-strength copper alloy
25⁄16"
⁄8"
5
⁄64"
5
⁄8"
3
• Hex head bolts with square shank of silicon bronze
• Spring washers also of silicon bronze
• Square shank bolts prevent turning while tightening
2"
• Contour of casting permits use of socket wrench if desired
• Large contact area increases conductance
• Not recommended for use with aluminum conductor
CAT. NO.
PC250
13⁄4"
CONDUCTOR RANGE AWG OR KCMIL (IN.)
MAIN
TAP
MAX.
MIN.
MAX.
MIN.
250 Str.
4 Sol.
250 Str.
CONDUCTOR DIAMETER
A
4 Sol.
One size fits all requirements from #8
solid copper to 1/0 ACSR or 2/0 copper.
Type K — Jumper Clamps
B
MAX.
MIN.
MAX.
MIN.
.575
.204
.575
.204
PLATED GROOVE
MAX.
MIN.
CAT. NO.
COPPER GROOVE
MAX.
MIN.
Plated with plating removed from one groove
121⁄64"
K1
11⁄8"
1/0 ASCR
2 SCG
amerductor
7
⁄16 galv.
strand
2/0 str.
copper
7
⁄16
Copperweld*
2A
Copperweld*
6 ACSR
12SCG
amerductor
8 solid iron
For use with aluminum, amerductor or galvanized steel strand to copper
or copper-bonded steel wires.
Clamp plated
EITHER GROOVE
MAX.
MIN.
CAT. NO.
19⁄32"
K2
1/0 ACSR
2 SCG amerductor
7
⁄16 galvanized
steel strand
6 ACSR
12 SCG
amerductor
8 solid iron
For use with amerductor, aluminum or galvanized steel stranding.
• Cast of high-strength copper alloy
Clamp, not plated
• Furnished with silicon bronze hex washer head bolt
• Parallel groove design — no need to remove bolt
for installation
• Available plated, unplated or with plating in one groove
C-48
www.tnb.com
United States
Tel: 901.252.8000
800.816.7809
Fax: 901.252.1354
2/0 str. copper
⁄16 copperweld*
2A copperweld*
K3
7
For copper-to-copper connections.
* Trademark of Copperweld.
Canada
Tel: 450.347.5318
Fax: 450.347.1976
Technical Services
Tel: 888.862.3289
8 solid copper
91⁄2D
copperweld*
etc.
8 solid
copper
9-12D
Copperweld*
etc.