Page 1 of 4
Universal Server Shelf Mounting Instructions
•
6640 185th AVE NE Redmond, WA 98052
(888)-828-POGO
Universal Server Shelf Mounting Instructions
Summary:
These instructions demonstrate how to properly setup and install the universal server
shelf. The setup and installation is easy but will require two people to complete. As with
any server, we highly recommend to have two people help with the mounting of the
system.
1) The first step to setting up the universl shelf system is to pull out the shelf and
verify that you have everything that you need to properly mount the shelf in the
rack (fig 1a).
1a
Parts List:
a) Two front “L” mounting brackets
b) Two rear extension arms
c) One sheet of SlipGaurd – anti slip material
d) One reversible shelf
e) One instruction book
f) Three bags of screws.
1: screws for brackets and arms.
2: screws and nuts to mount to round hole in rack.
3: screws and nuts for mounting in square holes.
1
Page 2 of 4
Universal Server Shelf Mounting Instructions
•
6640 185th AVE NE Redmond, WA 98052
(888)-828-POGO
2) After you have verified that all the screws and parts are there, attach the front “L”
bracket and rear extension arms to the shelf (fig 2a – 2b). (NOTE: When you
attach the rear extension arms, the screws will tighten down, but will leave the
arms free to slide along the length of the shelf.)
2a
2b
3) With the brackets and arms attached to the shelf, you can begin to mount the shelf
to the rack. These instructions will show how to mount the shelf to fit a server
more than 17.2” wide. If your server is less that 17.2” wide, you may mount the
shelf right side up. These instructions will work with the shelf right side up.
4) Each corner will use two screws and two nuts (fig 4a – 4b). There are two
different kinds of screws and nuts that come with this shelf kit: The first is for
Round holes. (These will be larger course screws with square nuts); the second
will be smaller screws with nuts that have clips attached to them. (These are for
square holes and hold the nuts in place when attaching the shelf.) Have another
person hold the shelf in place then screw all four corners secure to the rack.
(NOTE: if mounting the shelf upside down, you will need to compensate for the
extra spacing the shelf will use under the server. (This space will be 1U in size.)
4a
2
Page 3 of 4
Universal Server Shelf Mounting Instructions
•
6640 185th AVE NE Redmond, WA 98052
(888)-828-POGO
4b
5) When you have mounted the shelf in the rack, it will look like (fig 5a – 5c).
5a
5b
5c
3
Page 4 of 4
Universal Server Shelf Mounting Instructions
•
6640 185th AVE NE Redmond, WA 98052
(888)-828-POGO
6) When you are ready to place the server on the shelf, you may place the slipgaurd
(fig 6a) on the shelf first. Then place the server on the shelf (fig 6b – 6c).
6a
6b
6c
7) With the shelf and server mounted in the rack, you can begin to hook up your
server. You have completed the setup process for this universal shelving unit.
4