GLOBALContract • February 2011 DISASSEMBLY GUIDELINES Safety Glasses Rubber Mallet Boulevard System 3 Panel • BPX3PTxxxxx Required Tools: Required Tools Safety Glasses Wrench Required Tools: Safety Glasses Safety Glasses Rubber Mallet Flathead Screwdriver Pick Flathead Screw driver Actuator Rubber Mallet Rubber Mallet Pliers Flathead Screw driver Flathead Screw driver 10 mm Hex Bit Phillips Bit Actuator General Disassembly Actuator Product designed for disassembly in a reasonable time frame (5 minutes or less). Pliers a)Remove top cover (4). Pliers b)Remove B3 raceway cover (8). c)Remove B3 raceway outlet cover (10). d)Peel raceway bottom hinge (7) from steel covers. 10 mm Hex Bit e)Use sharp point to remove outer spline (13). 10 mm Hex Bit f) Use sharp point to remove inner spline (14). g)Remove inner and outer fabric (15, 16). h)Removed insulation (12). Phillips Bit i) Remove B3 panel glide leg brackets (5). Phillips Bit j) Remove B3 metal raceway lock (9). k)Remove masonite septum (11). T-25 Torx l) Remove masonite septum retaining clipsBit(17). 13 mm Socket Adaptor 1 16 18 15 19 14 Bit Adaptor / BitHandle Adaptor / Handle DESCRIPTION QTY Socket Wrench Vertical Extrusion Socket Wrench 2 Top Horizontal 1 Bottom Horizontal 1 Top Cover 1 B3 Panel Glide Leg Bracket 2 Extended Glide - 3”1313 mm Socket 2 mm Socket Raceway Bottom Hinge 1 Adaptor Adaptor Raceway Cover 2 Raceway Lock Clip 4 Raceway Outlet Cover 4 Masonite 1 Insulation 2 Outer Spline 2 Inner Spline 2 Fabric Inner 1 Fabric Outer 1 Masonite Clip 6 Mid Horizontal 1 Fabric 2 2 Socket Wrench T-25 Torx Bit # 1 2 3 4 5 6 7 8 utes or or9less less 10 11 12 13 14 15 16 17 18 19 4 Bit Adaptor / Handle Note: Chair can be disassembled in 5 minutes or less Sorted Materials T-25 Torx Bit MATERIAL Aluminum Aluminum Aluminum Aluminum Steel Steel / Nylon PVC Steel Steel Steel VERSION 2 03/18/10 VERSION 2 03/18/10 Fiberboard Mineral Wool PVC PVC Polyester Polyester Steel Aluminum Polyester 17 VERSION 2 03/18/10 3 13 12 11 9 10 7 6 5 8 Please contact your Global Contract Service Representative at 416-739-5000 for any questions or concerns. NOTE: Any alterations to listed components will void the manufacturer’s warranty. specifications. In accordance with the manufacturer’s policy of continual product The manufacturer will not be responsible for any damage or bodily harm caused improvement, the product presented in this document is subject to change by alterations in accordance with national or local electrical codes and manufacturer’s without notice or obligation.