ALLOW 6 3/4" MIN. FOR 171 COVER REMOVAL 6 1/8" 156 6 1/2" 165 7 1/8" 181 COVER WIRING TERMINALS POSITION SENSING DEVICE DIGITAL CONTROL MODULE STROKE ADJUSTMENT 13" 330 THIS DOCUMENT IS A COPY AND IS NOT THE SOURCE DOCUMENT. INFORMATION IS SUBJECT TO CHANGE WITHOUT NOTICE. THE INFORMATION CONTAINED HEREIN IS COPYRIGHTED BY HAROLD BECK AND SONS, INC. CHANGES TO THE DOCUMENT ARE PROHIBITED. CONTACT A BECK SALES ENGINEER IF A CERTIFIED DRAWING IS REQUIRED. 3/4" 19 2 7/8" 73 1" N.P.T. CONDUIT POWER CONNECTION 1" N.P.T. CONDUIT SIGNAL CONNECTION 18 3/4" 476 NAMEPLATE 10 3/8" 264 #10-32 EXTERNAL GROUND SCREW 5 1/8" 130 EXTENDED DIMENSION HANDSWITCH * * INTEGRAL TIGHTSEATER 8 3/4" 222 HANDWHEEL ALL DIMENSIONS ARE IN INCHES AND [MM] UNLESS OTHERWISE SPECIFIED. THREADS AND TAPPED HOLES ARE SPECIFIED AS UNIFIED THREAD SIZES ONLY. CONDUIT PIPE THREADS PER AMERICAN NATIONAL STANDARD TAPER PIPE THREADS (N.P.T.) VALVE STEM COUPLING VALVE BONNET MATCH LINE 3/4"-16 UNF THREAD X 11/16" [17] DEEP (ADAPTOR BUSHINGS FOR SMALLER THREADS) BECK DRIVE DRIVE SHAFT MODEL NO. TRAVEL RANGE 29-250 1/2"-2" [13-51] APPROX. WEIGHT LBS./KGS. 152/69 FASTENER GUIDE SIZE (IN.) COVER SCREWS MOTOR SCREWS 3/8-16 3/8-16 * TORQUE LB.-FT./Nm. 30/41 15/20 SIZE: TOLERANCE: ALL DIMENSIONS 1/4" [ 6] TYPICAL, MOUNTING FEATURES MAY VARY PER APPLICATION D HAROLD BECK & SONS INC. NEWTOWN INDUSTRIAL COMMONS TITLE: DRAWN: DWK 5-22-08 18-2920-01o THIRD ANGLE PROJECTION CHECKED: GMD 5-27-08 APPROVED: JHM 5-28-08 NEWTOWN, PENNSYLVANIA 18940 USA OUTLINE DIMENSIONS 29-250 DRIVES SCALE: NONE DRAWING NO: REV: 18-2920-01o SHEET NO. 1 OF 1 A