Mounting Kit Installation Guide
ANTENNA SOLUTIONS
36210006
2-Point Standard Mounting and Downtilt Bracket Kit
Front Pipe
Grip
Installation Instructions
1. Attach the Antenna to the upper and
lower Interface Brackets.
Interface
Bracket*
*NOTE: A Stainless Steel Washer must be
placed between Interface Bracket and antenna
z-bracket at each connection site.
2. Assemble the Front Pipe Grips and Upper
Scissor Bracket to the Interface Brackets
using 3/8” locking hardware.
Upper Scissor
Bracket
Rear
Pipe
Grip
Downtilt Position
Selector
3. Assemble Rear Pipe Grips with one 7” bolt
to the Front Pipe Grips. Raise antenna to
pipe. Insert second 7” bolt through Front
Pipe Grips and tighten to pipe.
Tighten the 7” bolts to 15Nm (11 ft-lbs)
Do NOT over-tighten. Excessive torque
loading will distort the Pipe Grip components.
4. Adjust the antenna to the desired downtilt
position. After adjusting, find the holes in
the Upper Scissor Bracket that align and
install the 1/4” locking hardware to both
sides.
Tighten the 1/4” hardware to 15Nm (11 ft-lbs)
Tighten the 3/8” hardware to 20Nm (15 ft-lbs)
5. Make all electrical connections and
weatherproof with self-amalgamating tape.
1 of 1
Front
Pipe
Grip
Rear
Pipe
Grip
Interface
Bracket*
www.amphenol-antennas.com
REV100312