AH3147 Unipolar, Ultra-Sensitive, Hall-Effect Switches AH3147E、AH3147L is the magnetic sensor that consists of voltage regulator,hall voltage generator, differential amplifier, Schmitt trigger and open collector output.When it detects the magnetic flux of density,it output digital voltage singal.It is the magnetic-sensing circuit that works by unipolar,and suitable for the rectangle magnet and the column magnet.Operating Temperature Range of AH3147L is -40~150 ℃ .It serves many applications within automotive,automation and industrial electronics.They have two package types:TO-92UA and TO-92T。 FEATURES TYPICAL APPLICATIONS Wide Supply Voltage Range Fast Response Time Wide Frequency(DC~100KHz) Long Operating Life, Small Size,Convenient Installing Direct connect with the transistor,TTL and MOS. . Contactless Switch . Speed Measurement . . Brushless DC Motor . Automotive Ignitor . Position Control Isolation Measurement Electric current sensor Alarm system . ABSOLUTE MAXIMUM RATING Parameter Symbol Value Unit Supply Voltage VCC 24 V Magnetic Flux Density B Output breakdown reverse voltage Vce 40 V Continuous Output Current IOL 25 mA AH3147L TA -40~150 ℃ AH3147E TA -20~85 ℃ 150 ℃ Operating Temperature Range Storage Temperature Range unlimited TS ELECTRICAL CHARACTERISTICS mT TA=25℃ Type and Value Parameter Symbol Test condition Unit min typ max 4.5 - 24 V Supply Voltage VCC Output Off Voltage VOL Iout=15mA B>BOP -- 200 400 mV Output Current IOH Vout=24V B<BRP -- 0.1 10 μ A Supply Current ICC VCC=24V Output Open -- - 10 mA - μ S - μ S Output Rise Time tr RL=820Ω CL=20PF -- 0.12 Output Fall Time tf RL=820Ω CL=20PF - 0.18 MAGNETIC CHARACTERISTICS VCC=4.5~24V Type and Value Parameter Symbol Unit min typ max Operate Point BOP - - 45 mT Release Point BRP 5.0 - - mT Hysteresis BH 3.0- 5 - mT 1mT=10Gs 1 AH3147 Hall Switch BLOCK DIAGRM MAGNETIC-ELECTRICAL TRANSFER CHARACTERISTICS 1,Vcc Vout REG 3,Vo BH BRP 2,GND BOP B TYPICAL OPERATING CHARACTERISTICS as a function of temperature Bop and Brp Output Saturation Voltage 300 400 300 Vcc=4.5-24V 200 BOP BRP 100 Vcc=8V 0 -50 0 -25 0 25 50 75 100 125 -50 Temperature Ta (℃) Package -25 0 25 50 75 100 Temperature Ta (℃) (unit:mm) 1.5 +0.1 4.06± 0.10 1.96 0.8 0.34 Depth Branded 0.43 surface 0.38 Lead Designator 1. SUPPLY 2. GROUND 0.38 1 2 3 3. OUTPUT 1.27 2.34 45 TO-92UA Package and active area Cautions 1. When install, should as full as possible decrease the mechanical stress acting on the Hall IC, to avoid the influence of the operate point and release point. 2. On the premise of ensuring welding quality, use as possible as low welding temperature and short time. AH3147 Hall Switch 125