Panel Management System Installation Instructions HFPP66 HFPP86 HFPP108 HFPP120 HFPP142 222 N. Union St. Bryan, OH 43506 PH: 419-636-4217 FAX: 800-237-7269 www.alliedmoulded.com 17-HFPPSHEET PAGE #1 RELEASE DATE: 6/13/11 #6-32UNC Screw #6 Flat Washer Instructions for Mounting Hinge to Front Panel Step #1 Front Panel Place (1) #6-32UNC hex nut into (1) hinge (Hold in place) Install (1) #6-32UNC x 3/8” pan head screw with (1) #6 flat washer through the front panel and the hinge into the hex nut. Repeat steps 1 and 2 for other Screw. Repeat steps 1-3 for other Hinge. Step #2 Step #3 Step #4 Hinge #6-32UNC Hex Nut #10-32UNC Screw Hinged Front Panel Assembly Instructions for Mounting Hinged Front Panel Step #1 Step #2 Step #3 Step #4 Step #5 Step #6 Install (1) corner slider in each corner slot opposite hinge side Install (1) #4-40UNC x 1/4” socket head cap screw into each of the holes of the corner sliders evenly until the screw head touches the slider’s flange to lock them in place. (Use the included hex key, Do NOT over tighten) Install (1) corner slider on each side of the hinged front panel assembly as shown. Install the hinged front panel assembly with the corner sliders into the hinged side of box Install (1) #4-40UNC x 1/4” socket head cap screw into each of the holes of the corner sliders evenly until the screw head touches the slider’s flange to lock them in place. (Use the included hex key, Do NOT over tighten) Install (1) #10-32 x 5/16” screw in corner sliders opposite hinge if desired, to lock panel in place. #4-40UNC Screw Corner Slider Note: maximum install depth for the hinged front panel is 1.5” from the top of the box. 17-HFPPSHEET PAGE #2 RELEASE DATE: 6/13/11 Din Rail (Not Included) #10 Sheet Metal Screw (Not Included) #10 Sheet Metal Screw (Not Included) Din Rail (Not Included) Instructions for Mounting the Din Rail Step #1 Step #2 Cut and place the Din Rail in the position preferred on (2) bosses on bottom of box. Install (2) #10 x 3/8” sheet metal screws into the boss holes and tighten. *Din rails not available through Allied Moulded products #10-32UNC Screw Back Panel Instruction for Mounting the Stationary Back Panel Step #1 Step #2 Place the back panel with the plastic covered side up on the (4) bosses on bottom of box. Install the (4) #10-32UNC x 5/16” pan head screws into the (4) brass inserts in bottom of box. (screws were supplied with the enclosure) 17-HFPPSHEET PAGE #3 RELEASE DATE: 6/13/11 17-HFPPSHEET PAGE #4 RELEASE DATE: 6/13/11