LLX18-RGB Wet Color-changing linear LED strip for wet locations - 24V The LLX18-RGB Wet is a small profile and energy efficient color-changing light strip. It is easily installed directly on to the mounting surface with double sided tape or within discrete mounting extrusions. The durable but flexible circuit board enables the perfect fit for every application. Applications: Indoor/outdoor use, exterior accents, decks, gazebos, barbecue stations, wet bars, signage, etc. Line LED RGB wet location Operating voltage 24 VDC (RGB controller and PSV series power supply required) Beam Angle 120˚ Average life 50,000 hours Mounting LLX18-RGB strip is equipped with 3M self-adhesive tape. Mounting to an aluminum profile or the HST aluminum heat sink tape is required to reach the rated 50,000 hours average life. Approvals cETLus listed for wet locations Technical specifications MODEL LLX18-RGB LEDs/ft 18 Light output Section start/end options 169 lumen/ft* Average power consumption (for 15’ section 4.6 W/ft* Amperage load at maximum run 4.0 A Ordering increment 4.00” Maximum run length 30 ft Soldered leads (72”) No connector 0.39” W 0.11” H Dimensions *with all 3 circuits at full brightness Ordering code MODEL LLX18WET-RGB LLX18WET-RGB REV3.3 SECTION START SL SL - Soldered lead wires (72”) SECTION END LENGTH NC NC - No connector SL - Soldered lead wires (72”) View specifications for increment options page 1 of 3 www.luminii.com tel: 224-333-6033 LLX18-RGB Wet Color-changing linear LED strip for wet locations - 24V Power consumption per linear foot* Accessories * with all 3 circuits at full brightless Mounting clip Length of Strip (LF) W/ft Total wattage Length of Strip (LF) W/ft 1 4.60 4.60 16 3.85 61.60 2 4.55 9.10 17 3.75 63.75 Part # CL -1 Total wattage 3 4.50 13.50 18 3.70 66.60 4 4.45 17.80 19 3.65 69.35 5 4.40 22.00 20 3.60 72.00 6 4.35 26.10 21 3.55 74.55 7 4.30 30.10 22 3.45 75.90 8 4.25 34.00 23 3.40 78.20 9 4.20 37.80 24 3.35 80.40 10 4.15 41.50 25 3.30 82.50 11 4.10 45.10 26 3.25 84.50 12 4.05 48.60 27 3.15 85.05 13 4.00 52.00 28 3.10 86.80 14 3.95 55.30 29 3.05 88.45 15 3.90 58.50 30 3.00 90.00 0.19” 0.05” 0.40” 1.00” 0.23” Heat sink tape Part # HST 2.00” RGB Controllers See Luminii website for further information on each controller. Models RGB-MC2 RGBW -RC TSDMX Zones up to 4 up to 64 up to 1024 Receiver # input range capacity RGB-MC2-R 12-36 VDC 96W at 24V RGBW-RC-R 12-36 VDC 96W at 24V DDMX-RGBW 12-36 VDC 96W at 24V Dimensions L 4.75” W 2.13” H 0.78” L 4.49” W 2.24” H 0.44” L 6.56” W 5.00” H 0.44” Functions - multiple zone control - program custom color sequences - brightness and speed control - pause option - multiple zone control - RGB and white light LED control - pre-programmed modes - brightness, speed and saturation control - multiple zone control - RGB and white light LED control - program custom color sequences - advanced color controls through digital software Power supply See fixture and power supply instructions & spec sheet for wiring information. MODEL PSV PSV - PSV Series REV3.3 POWER 40 40 - 40 W 60 - 60 W 96 - 96 W OUTPUT 24V 24 - 24 VDC DIMMING U2ND U2ND - Non Dimming LOCATION D D - Dry Location IP65 - Wet Location page 2 of 3 www.luminii.com tel: 224-333-6033 LLX18-RGB Wet Color-changing linear LED strip for wet locations - 24V Optional mounting channels - Single row LEDs Alu-Corner Alu-45 Alu-Roun d 0.99” 0.94” 1.20” 0.72” 0.33” 0.69” CL HF F N M CL HF F N M CL F Recessed Slim Line 7 Slim Line 7 Slim Line 15 0.69” 0.69” 0.95” 0.27” 0.59” 0.27” 0.69” CL HF F N M CL HF F N M Recessed Slim Line 15 CL HF F N M Alu-Fl at 0.63” Alu-Wall 0.95” 2.05” 0.59” 0.30” 2.76” 0.69” CL HF F N M CL HF F N M Slim Wi de 8 2.36” CL F Recessed Slim Wi de 8 Slim Wi de 15 0.88” 0.88” 1.16” 0.61” 0.33” 0.30” 0.88” CL F CL F CL F Alu- ETC Alu-St air 1.45” 0.87” 2.43” 1.07” 1.77” 0.84” Lens options CL 0.81” 1.74” F HF CL F CL F N M Optional mounting channels - Double row LEDs Power Line 30 Installation Recessed P ower Line 30 1.17” All mounting channels are field cuttable using miter saw with circular blade suitable for cutting aluminum. 1.57” 2.63” 2.05” CL F Clear Frosted Half (50%) frosted Narrow beam frosted Medium beam frosted CL F Lenses and endcaps to be siliconed for wet location applications. 1.18” Ordering Recessed P ower Line 35 Power Line 35 1.73” 1.37” CL F REV3.3 1.37” Extrusions are sold separately. View respective specsheets for details on ordering extrusions and their accessories (endcaps, mounting brackets, etc). 1.37” 1.37” CL F page 3 of 3 www.luminii.com tel: 224-333-6033