®
-J02043 REV. 4-12-00
Kit Numbers 52067-97A
This seat fits 1997 and later Road King model motorcycles.
This seat cannot be used alone as a solo seat. The seat must be installed with an appropriate tail section kit.
See your Harley-Davidson Dealer for the various tail section accents available.
1
2
QTY DESCRIPTION
2
2
Washers
Screw, socket head (1/4-20 x 7/8 in.)
Seat, solo
Plastic plugs
PART NO.
6703
4015
Not sold
763
NOTE
Service Parts are available for the Part Numbers. listed above.
i02100
Stud plate (1998 and later models)
Nut
Front seat
Figure 1. Remove original seat
1
WARNING
Do not attempt to carry a passenger with this seat installed. Use of a luggage rack, fender, or tail section as an additional seat may result in death or serious injury.
i02101
NOTE
When this seat is installed, the passenger foot pegs or foot boards, and the passenger grab strap must be removed.
1.
See Figures 1 and 2. Using the 5/8 hex, remove two nuts from studs. Remove the seat mounting studs securing rear of rider seat. Remove c-clips and retention nuts. On 1998 and later vehicles remove the stud plate that holds the rear portion of the original solo seat. Install plastic plugs where retention nuts were removed.
2.
See Figure 3. Push front seat rearward to free tongue from slot in frame backbone.
3.
Refer to tail Section Instruction Sheet for instructions describing how to attach the tail section and seat to the motorcycle.
Seat bottom
Tongue
Figure 2. Plastic Seat Plug i02102 i02103
1
WARNING
After installing seat, pull upward on front of seat to be sure it is locked in position. If seat is loose, it could result in shifting during vehicle operation, loss of control of vehicle, death or serious injury.
Slot
Frame backbone
Figure 3. Seat Mounting