HOW TO REMOVE DOOR MECHANISM? (RM3)
TOOLS NEEDED: #2 and #3 PHILLIPS HEAD SCREWDRIVER, FLAT HEAD SCREWDRIVER, PENCIL
Hinge Cover
Screws
Door Hinges
Cap and screw
Step 1: Open door and remove 2 door hinge
cover screws with #2 Phillips head
screwdriver.
Step 2: Trace and mark around the door hinges
with a pencil. Close door and lock handle as
shown above. Remove 6 door hinge screws
with a #3 Phillips head screwdriver. * Do not
have fingers between hinge and hinge block
while removing bottom screws.
Step 3: Remove door from the tub and place
the door on a flat surface. Be careful not to
scratch or damage the gelcoat. Open white
screw cap cover and remove screw from
handle. Remove handle from door.
Screws
Screws
Step 4: After removing handle, remove 2
screws as shown above.
Step 5: Remove white circle piece.
Step 6: Remove 2 screws on bottom of door
mechanism. Pull mechanism straight out of door.
HOW TO INSTALL DOOR MECHANISM? (RM3)
TOOLS NEEDED: #2 and #3 PHILLIPS HEAD SCREWDRIVER, FLAT HEAD SCREWDRIVER, PENCIL
Hinge
Screw
holes
Step 1: Place new or repaired mechanism in
door as shown above.
Screws
Step 2: Install two 10-24 x 1” screws. As
shown above.
Step 3: Insert white circle piece. Attach with two
10-24 X 1/2” screws. If screws will not thread
into mechanism, go to Step 4. If screws thread
properly and tighten, skip to Step 5.
Cap and screw
Step 4: If small screws will not attach to
mechanism, remove the 10-24 x 2 ½” screw used
for the handle and place in center hole of white
circle piece. Thread enough to get screw to hold
and pull outward on screw. This will pull the
mechanism closer to the white circle piece allowing
the 2 small screws to thread in properly. Tighten 2
small screws and remove the handle screw.
Step 5: Place handle back on door and
add the 10-24 x 2 ½” screw and white
screw cap cover. Tighten screw and close
white screw cap cover.
Step 6: Put door back on tub. Pull down on door
hinge and add 3 hinge screws to bottom. Then
add 3 hinge screws to top. Line door hinge up with
pencil marks that were made before door was
removed. Screws can be loosened or tightened as
needed to line door up with lines. After door is in
correct position, tighten all hinge screws with #3
Phillips head screwdriver.