Resistors
NOT RECOMMENDED FOR NEW DESIGNS
Make Possible
Molded Zero Ohm OBSOLETE
Jumper Wires
Molded Zero Ohm
Zerohm Series
Jumper
Wires
1/4 Watt size
Less than 0.01Ω
Zerohm
Series available under DESC dwg 87009
MIL version
• 1/4
Watt sizeon lead tape and reel for automatic insertion
Supplied
• Less than 0.01Ω
• MIL version available under DESC dwg 87009
• Supplied on lead tape and reel for automatic insertion
All Pb-free parts comply with EU Directive 2011/65/EU (RoHS2)
IRC’s jumper wires offer a quick, simple solution for circuit board
IRC’s jumper wires offer a quick, simple solution for circuit board point-to-point connections or crossovers.
point-to-point connections or crossovers. These are also used for
These are also used for after-the-fact design change that requires new point connections, connect two points
after-the-fact design change that requires new point connections, connect two points on a circuit board due
onother
a circuit
board
duewhich
to other
circuit
paths which must
be crossed-over,
and circuit
tuning
by changing
point
to
circuit
paths
must
be crossed-over,
and circuit
tuning by changing
point
connections.
These
connections.
These
are
especially
suited
for
automatic
machine
insertion
on
lead
tape,
and
are
available
in all
are especially suited for automatic machine insertion on lead tape, and are available in all packing styles
packing
styles
including
pre-cut
and
formed
leads
for
manual
insertion.
including pre-cut and formed leads for manual insertion.
Specification Data
Maximum Resistance
0.01Ω max
Lead Material
Solder coated copper clad steel
Body Material
Electrical grade, high performance, coating and molding compounds
Minimum Insulation Resistance
Dry, 10,000 Megohm; Wet, 100 Megohm
Minimum Dielectric Withstanding Voltage
Atmospheric, 500V RMS; Reduced, 325V RMS
Current Rating
15 amps at 70°C for 1/4W max 3A continuous
Packaging
5000/reel or 1000/bulk
Physical Data
d
H
H
L
D
Dimensions
UNIT
L
D
H
d
Molded 1/4 W
0.250″ ± 0.015
(6.35mm ± 0.381)
0.090″ ± 0.008
(2.3mm ± 0.2)
1.50″ ± 0.125
(38.1mm ± 3.2)
0.025″ nom.
(0.63 nom)
Note: All parts marked with black band
Product Ordering
Information:
Ordering
Data
RG
¼ Zerohm
LF for ordering information.
Contact
factory
General Note
General
Note
IRC
reserves the
right to make changes in product specification without notice or liability.
All
is subject
to IRC’s
own data
and is considered
at time
of going to print.
TTinformation
Electronics
reserves
the right
to make
changes accurate
in product
specification
without notice or liability.
AllIRC
information
is subject
to Film
TT Electronics’
own data
and is considered
accurate
at time
of going
print.
©
Wirewound
and
Technologies
Division
• 4222 South
Staples Street
• Corpus
Christito
Texas
78411 USA
Telephone: 361 992 7900 • Facsimile: 361 992 3377 • Website: www.irctt.com
A subsidiary of
TT electronics plc
www.ttelectronicsresistors.com
Zerohm Series
Issue January 2009 Sheet 1 of 1
© TT Electronics plc
10.14