HP StorageWorks
Operator Control Panel
replacement instructions
About this document
This document describes the procedure for replacing the Operator
Control Panel (OCP).
CAUTION:
This procedure assumes the storage system is running XCS 6.000
or later. If you are running an earlier version of XCS, contact your
HP-authorized service representative for assistance in replacing
the OCP.
Warranty information
These instructions apply to the EVA4000/6000/8000
products. The part may also be used in other HP
products. See the documentation for your product for
detailed replacement instructions.
If the product in which this part is being replaced is still under
HP warranty, then the replacement part(s) referred to in these
Replacement Instructions is provided under the terms and conditions
of the Hewlett-Packard Company Limited Warranty for that
product. A copy of this Limited Warranty may be viewed at:
http://h18006.www1.hp.com/products/storageworks/warranty.html
If this is a trade sale part (product out of warranty), then the replacement
part(s) referred to in these Replacement Instructions is provided under
HP's express limited warranty statement, which may be viewed at:
http://customerops.corp.hp.com/1sw/pdm_om/warranty_support/
policies/2330100.doc
The replacement part takes on either the Limited Warranty Period of the
part being replaced or a ninety-day period that begins upon installation
of the replacement part, whichever is greater.
The only warranty for this replacement product is as noted above.
Nothing in these replacement instructions should be construed as
constituting an additional warranty. The information provided in these
replacement instructions is provided "AS IS" and HP is not liable for
technical or editorial errors or omissions contained herein.
© Copyright 2006–2007 Hewlett-Packard Development Company,
L.P.
Second edition: April 2007
The information in this document is subject to change without
notice.
Printed in the U.S.A.
www.hp.com
Before you begin
Observe the following precautions when replacing the OCP:
• Removing the OCP significantly changes the air flow within the
enclosure. The OCP must be installed for the enclosure to cool
properly. If the OCP fails, leave it in place in the enclosure until a
new OCP is available to install.
• Parts can be damaged by electrostatic discharge. Use proper
anti-static protection.
• Use care when replacing the OCP to avoid damaging the enclosure.
Removing the OCP
1.
Remove the front panel (1, Figure 1) by grasping the panel at each
end pulling it off the enclosure.
2. Press the OCP latch (2) and swing the panel out until it is fully open.
CAUTION:
Handle the OCP by its metal frame only. This will ensure that the
electronic components are not damaged by static discharge.
3. Grasp the OCP by its metal frame and pull it out of the enclosure
(3).
5697-6582
Page 1
2
3
1
0142b
Figure 1 Removing the OCP
Installing the OCP
1. Slide the new OCP into the enclosure (1, Figure 2).
2. Close the OCP until the latch engages.
3. Install the front panel, pressing it firmly into place.
NOTE:
After installing the OCP, the controller may have to upgrade the
OCP firmware. Do not remove the OCP while this operation is in
progress. When the OCP is displaying the alternating Storage
System Name and WWID, the correct firmware has been loaded
on the OCP.
1
0143b
Figure 2 Installing the OCP
Verifying proper operation
After replacing the OCP, verify that it is operating properly:
1. Check the display. It will typically display the default information
which alternates between the Storage System Name and the World
Wide Name.
2. Press any push button. The Storage System Menu Tree should be
displayed.
Returning the failed component
Follow the return instructions provided with the new component.
Page 2