Next
Round End Shell Assembly Installation
DRAWER REMOVAL
Special Tools
( If Required for Access)
Level
1/4" deep well socket
Drill w/ 9/32" bit
2" Metal Frame Drawers
or
Writing Surface Assembly
Right-Hand
Assembly
Step 1: Lift or push down
release levers (one per side)
and slide out drawer assembly
All Molded Drawers
Step 1: Pull drawer outward
until it hits stop.
DA2192i
Left-Hand
Assembly
Models:
DM-OAC010R
DM-OAC010L
OSC010R
OSC010L
DA2163i
( Right Hand Unit )
( Left Hand Unit )
( Right Hand Unit )
( Left Hand Unit )
© Midmark Corporation 2003
Style A
Step 2: Pull sides of drawer
outward while lifting to free
back of drawer from hooks
and remove.
Page 1 of 4
003-1400-00 Rev. B (3/09)
Back
Next
CONNECTING ROUND END
SHELL ASSEMBLY
Step 1:
Before installing a right-hand
assembly, drill nutserts out of
base cabinet.
Base
Cabinet
LL
A
W
Right-Hand
Assembly
Special hex bolts
(#10-24 x 3/4")
Left-Hand
Assembly
Step 2:
DE
SIR
ED
PO
SIT
I
ON
OF
ED
G
EO
FU
DA2193i
NI
© Midmark Corporation 2003
T
Page 2 of 4
Place assembly in position
and secure with special
(#10-24 x 3/4") hex bolts.
Back
Next
COUNTERTOP
NOTE:
If necessary, sand
countertop to form
to wall.
Step 1: Position countertop so it
extends 3/8" (0.95 cm) to
1/2" (1.3 cm) over each
end of cabinet(s) and secure
with #10 x 5/8" screws.
Right-Hand
Assembly
Base
Cabinet
Step 2:
Left-Hand
Assembly
Remove bottom
drawer or bottom
panel from cabinet.
DA2194i
Step 4: Level cabinet with
leveling screws.
LOWER
CABINET
RAISE
CABINET
Equipment Alert
Do not adjust leveling
screws more then 1 1/2" (3.8 cm)
to prevent loss of stability.
© Midmark Corporation 2003
1 1/2" (max.)
(3.8 cm)
Page 3 of 4
Step 3:
Adjust leveling screws
to fully lowered position
and move cabinet to
desired position.
Back
Midmark Corporation
60 Vista Drive
P.O. Box 286
Versailles, OH 45380-0286
937-526-3662
Fax 937-526-5542
www.midmark.com
© Midmark Corporation 2003
Page 4 of 4