Supplementary Installation Instructions for:
Supplementary Installation Instructions for:
Emergency Lighting Luminaire
Emergency Lighting Luminaire
The emergency lighting module contains a battery charger, battery charge indicator, transistorised inverter and mains sensing
changeover device to provide maintained emergency lighting.
The emergency lighting module contains a battery charger, battery charge indicator, transistorised inverter and mains sensing
changeover device to provide maintained emergency lighting.
The battery fitted in this luminaire is specified and tested for essential characteristics, the performance cannot be guaranteed with
alternative batteries. Operation in ambient temperatures outside the range indicated in the luminiare instruction leaflet or marked on
the luminaire will reduce the battery life.
The battery fitted in this luminaire is specified and tested for essential characteristics, the performance cannot be guaranteed with
alternative batteries. Operation in ambient temperatures outside the range indicated in the luminiare instruction leaflet or marked on
the luminaire will reduce the battery life.
Fixing
See luminaire instruction leaflet. Care should be taken when handling batteries, under no circumstances short-circuit the battery
terminals. Mark date of commissioning on the battery label.
Fixing
See luminaire instruction leaflet. Care should be taken when handling batteries, under no circumstances short-circuit the battery
terminals. Mark date of commissioning on the battery label.
Wiring
Integral luminaire - connect to mains supply as shown in fig. 1.
Wiring
Integral luminaire - connect to mains supply as shown in fig. 1.
FIG. 1 LUMINIARE WITH INTEGRAL MODULE AND BATTERY
SUPPLY N
MAINS
UNSWITCHED L
FIG. 1 LUMINIARE WITH INTEGRAL MODULE AND BATTERY
SUPPLY N
MAINS
UNSWITCHED L
N
L
L1
LUMINAIRE UNIT MUST BE EARTHED
NORMAL LIGHTING
SWITCH
N
L
L1
LUMINAIRE UNIT MUST BE EARTHED
NORMAL LIGHTING
SWITCH
TEST SWITCH
TEST SWITCH
The test facility is optional. If the test device is manually operated it must be self-resetting or key operated to prevent unauthorised
operation
The test facility is optional. If the test device is manually operated it must be self-resetting or key operated to prevent unauthorised
operation
Testing
Connect the permanent (unswitched) mains supply and check the green indicator lamp is alight, no other lamps should be alight.
Briefly switch on the switched mains supply and check all the normal lamps lighten switch off the switched mains supply. Allow
approximately 15 minutes charge period, then briefly disconnect the unswitched mains supply and check the emergency lamp lights and
the green indicator lamp extinguishes. If any lamp fails to light disconnect the battery and check all connections and the fit of the lamp(s)
in the lampholders. Repeat the initial installation check, if the emergency lamp still fails to light allow the battery to charge fro 24 hours
before re-checking emergency operation.
Testing
Connect the permanent (unswitched) mains supply and check the green indicator lamp is alight, no other lamps should be alight.
Briefly switch on the switched mains supply and check all the normal lamps lighten switch off the switched mains supply. Allow
approximately 15 minutes charge period, then briefly disconnect the unswitched mains supply and check the emergency lamp lights and
the green indicator lamp extinguishes. If any lamp fails to light disconnect the battery and check all connections and the fit of the lamp(s)
in the lampholders. Repeat the initial installation check, if the emergency lamp still fails to light allow the battery to charge fro 24 hours
before re-checking emergency operation.
IMPORTANT: If the luminaire is not being immediately commisioned, ie left on mains supply, the battery must be disconnected to
prevent discharge.
IMPORTANT: If the luminaire is not being immediately commisioned, ie left on mains supply, the battery must be disconnected to
prevent discharge.
DO NOT TEST MAINS INSULATION WITH THIS LUMINAIRE OR REMOTE UNIT CONNECTED.
DO NOT TEST MAINS INSULATION WITH THIS LUMINAIRE OR REMOTE UNIT CONNECTED.
Safe Operation
1. Check the luminaire and module rating labels fro voltage and frequency before connecting to the electrical supply.
2. Ensure the mains supply is switched off and the battery disconnected when working on this luminaire whether installing, relamping, or
other servicing.
3. Use the correct lamps and battery as indicated.
4. Ensure the fixing is adequate for the luminaire weight involved.
Safe Operation
1. Check the luminaire and module rating labels fro voltage and frequency before connecting to the electrical supply.
2. Ensure the mains supply is switched off and the battery disconnected when working on this luminaire whether installing, relamping, or
other servicing.
3. Use the correct lamps and battery as indicated.
4. Ensure the fixing is adequate for the luminaire weight involved.
Servicing and Disposal
Servicing and Disposal
1. At commissioning and handling over of installation ensure this instruction leaflet and recommendations for periodic inspection and test
are presented to the authority responsible for the operation and maintenance of the luminaire.
2. Servicing, eg, cleaning and lamp replacement, must only be carried out after the electrical supply has been switched off. Do not
assume a luminaire with lamps not lit is switched off - always check before servicing. Do not touch lamp pins or any terminals without
first disconnectingthe battery.
3. Cleaning should be carried out at regular intervals to ensure dirt does not accumulate to an extent that will impair the thermal safety
of the luminaire. Regular cleaning will also ensure the optical performance of the luminaire is maintained.
4. Failed lamps, starter switches and batteries must be replaced as soon as practicable by components of the same type.
Replace battery when module is unable to achieve the rated duration marked on the module.
5. Batteries must not be disposed of by fire or mutilated in any way.
1. At commissioning and handling over of installation ensure this instruction leaflet and recommendations for periodic inspection and test
are presented to the authority responsible for the operation and maintenance of the luminaire.
2. Servicing, eg, cleaning and lamp replacement, must only be carried out after the electrical supply has been switched off. Do not
assume a luminaire with lamps not lit is switched off - always check before servicing. Do not touch lamp pins or any terminals without
first disconnectingthe battery.
3. Cleaning should be carried out at regular intervals to ensure dirt does not accumulate to an extent that will impair the thermal safety
of the luminaire. Regular cleaning will also ensure the optical performance of the luminaire is maintained.
4. Failed lamps, starter switches and batteries must be replaced as soon as practicable by components of the same type.
Replace battery when module is unable to achieve the rated duration marked on the module.
5. Batteries must not be disposed of by fire or mutilated in any way.
Cooper Lighting and Safety Ltd
Cooper Lighting and Safety Ltd
Wheatley Hall Road, Doncaster, South Yorkshire, DN2 4NB
Wheatley Hall Road, Doncaster, South Yorkshire, DN2 4NB
Cooper Lighting and Safety Ltd
Cooper Lighting and Safety Ltd
Wheatley Hall Road, Doncaster, South Yorkshire, DN2 4NB
Wheatley Hall Road, Doncaster, South Yorkshire, DN2 4NB
Sales
Sales
Sales
Sales
General
General
Major Projects London
Export
Major Projects London
Export
T: +44 (0)1302 303303
+44 (0)1302 321541
+44 (0)1992 787999
+44 (0)1302 303250
T: F:
+44
(0)1302
303303
+44
(0)1302
321541
+44
(0)1992 787999
+44
(0)1302
303250
+44
(0)1302
367155
+44
(0)1302
303220
+44(0)1992
787222
+44
(0)1302
303251
F: E:
+44
(0)1302 367155
+44
(0)1302 303220
+44(0)1992
787222
+44
(0)1302 303251
sales@cooper-ls.com
technical@cooper-ls.com
london@cooper-ls.com
export@cooper-ls.com
E: sales@cooper-ls.com
technical@cooper-ls.com london@cooper-ls.com export@cooper-ls.com
K841V1
General
General
Major Projects London
Export
Major Projects London
Export
T: +44 (0)1302 303303
+44 (0)1302 321541
+44 (0)1992 787999
+44 (0)1302 303250
T: F:
+44
(0)1302
303303
+44
(0)1302
321541
+44
(0)1992 787999
+44
(0)1302
303250
+44
(0)1302
367155
+44
(0)1302
303220
+44(0)1992
787222
+44
(0)1302
303251
F: E:
+44
(0)1302 367155
+44
(0)1302 303220
+44(0)1992
787222
+44
(0)1302 303251
sales@cooper-ls.com
technical@cooper-ls.com
london@cooper-ls.com
export@cooper-ls.com
E: sales@cooper-ls.com
technical@cooper-ls.com london@cooper-ls.com export@cooper-ls.com
Lighting
K841V1
Lighting