Signal conditioning modules
Module
OD2
OD4
OD5
DRC
BICM
13-42 VDC
10-30VDC
90-264VAC
10-30VDC
±15VDC
24VDC
<30
140-50
250-100
160-70
±12
24
Power Requirement
Input Voltage
Input Current (mA)
Frequency (Hz)
OD series
-
47-63
-
Sensor Excitation
Primary voltage (Vrms)
The OD series of conditioning
units is used to interface with
Solartron‘s sensors to provide
different functionality to suit different
applications.
0-9
Primary frequency (kHz)
1.2 - 2.1
3
5 or 13
2.5 or 5
-
5,10 or 13
5
Signal Input
30-530mV/V1
Input Range
55 to 5000mV LVDT full range
up to 3.5
Input Load (k1)
2
2, 10, 100
2, 100
100
The OD2 is a two wire 4-20mA
signal conditioner. It is designed for
long distance signal transmission
due to low noise susceptibility. A
cable break results in no current flow
indicating a fault.
Options
-
Forward and reverse polarity,
half bridge
see note 2
-
The OD4 (OD5 is a mains powered
equivalent) is a signal conditioning
unit powered from a single 1030VDC supply. The outputs are
fully adjustable allowing a range of
voltage and current outputs to be
selected.
Output Ripple
Signal Output
Voltage Output
-
Up to ±10
Current Output
4-20
Up to ±20 into 1501 load
<38µA rms
<1 mV rms
Output Offset
-
<14
Up to 100% on maximum gain (coarse and fine adjustment)
Temperature Coefficient Gain (%FSO/°C)
<0.01
Temperature Coefficient Offset (%FSO/°C)
<0.01
<0.03
<0.02
Warm Up (minutes)
15 minutes
Linearity (%FSO)
<0.02
Bandwidth (-3dB) (Hz)
25
<0.1
500Hz, 1khz
250
-20 to +80
-
Environmental
Storage Temperature
-40 to +80
Operating Temperature
IP rating
0 to +60
65
-
40
None
IP40/67
IP40
Mechanical
Sensor connections
Terminals
DIN connector
-
Terminals
Solder tag or factory fit for IP67
Power connections
Terminals
-
IEC320 C14
-
-
Weight
Material
Mounting
Module
DRC DIN rail module
The DRC is a DIN rail mounted
version of the OD4 (see above).
BICM in line module
The BICM provides a simple low
cost in line conditioning unit. This is
designed for use where the sensor is
in a harsh environment as the BICM
can be connected up to 10m from
the sensor. An IP67 variant of the
BICM is also available.
ATM TTL converter
TTL RS 232 Differential Quadrature
is one of the most commonly used
methods of communication between
Linear Displacement Sensors and
Control or Data Acquisition Systems.
Its simplicity of Interfacing with
programmable systems also makes
Solartron‘s ATM one of the most cost
effective.
ABS
Painted Aluminium Box
Plastic
Plastic or Stainless Steel IP67
Holes
-
DIN rail
-
ATM TTL converter
Measurement
Sensor types
Accuracy (%FSO)
Resolution (x4 interpolation)
Repeatability
All Solartron Displacement Sensors
Note 1: For sensors with sensitivity > 250mV/V,
an adjustable attenuator is required- contact
sales
Note 2: Sensor is connected via external screw
terminal user can therefore configure options
Note 3: For higher environmental levels(and other
custom options) contact sales office
<0.25
0.1
sensor dependent
Electrical
Power
Output Signal
Output frequency (kHz)
Bandwidth
+5 ±0.25 VDC @ 100 mA
A and B, /A and /B TTL square waves RS422 levels
50, 100, 125, 250, & 500 (factory selectable)
100 Hz
Also see...
Environmental (electronics)
Sealing
Operating temperature (°C)
Storage temperature (°C)
IP43
Dimensions and drawings
Page 40
X
0 to +60
-20 to +70
Refer to product manual 502724 for details of operation – contact sales office/web site
26 www.solartronmetrology.com
www.solartronmetrology.com 27
Orbit® interface components dimensions (mm)
Signal conditioning modules dimensions (mm)
PIEPIE
(Probe
(Probe
Interface
Interface
Electronics)
Electronics)
OD4
72.00
9XXXXX-X
XXXA123YZZ
DP/XX/X
9XXXXX-X
XXXA123YZZ
39.00
39.00
56.00
DP/XX/X
OD5
112.00
120.00
56.50
77.50
OD2
17.70
56.50
72.00
77.50
50.00
112.00
65.00
120.00
108.00
65.00
80.00
17.70
Ø3.20 x 8.00 deep holes in 4 positions
Ø4.00 mounting holes in 4 positions
120.00
49.00
OD series
23.00
61.0061.00
8.25
6.25
ATM TTL converter
138.00
31.00
124.00
4.00
Ø4.00
Ø3.50
T-CON
Orbit
network
connector
T-CON
Orbit
network
connector
66.00
66.0066.00
60.25
65.0065.00
16.4016.40
35.00
BICM in line module
Ø 20.65
IP67
111.00
46.00
34.35
46.00
8.00
19.90
47.80
10.50
DRC DIN rail module
73.0 MAX.
46.00
34.35
6.00
30.00
7.00
6.25
8.50
35.0035.00
LEDs
16.40
65.00
71.5071.50
22.50
Ø 20.55
19.9019.90
23.2023.20
2 OFF M4 MOUNTING POSITIONS
Ø3.50
19.0019.00
MOUNTING
MOUNTING
19.00
19.0019.00
MOUNTING
MOUNTING
99.00
95.80
12.60
30.60
IP40
OUTPUT
19.00
TRANSDUCER
23.20
23.90
114.50
VIEW VIEW
SHOWING
SHOWING
3 ASSEMBLIES
3 ASSEMBLIES
PLUGGED
PLUGGED
TOGETHER
TOGETHER
T-CON
T-CON
withwith
32 mm
32 mm
DINDIN
raiseraise
connector
connector
40 www.solartronmetrology.com
VIEW SHOWING 3 ASSEMBLIES PLUGGED TOGETHER
T-CON with mounting feet option
www.solartronmetrology.com 41