Catalog Number
Notes
Type
FEATURES & SPECIFICATIONS
CONSTRUCTION
10% maximum total harmonic distortion (THD).
Series circuit wiring.
Programmed rapid start.
High power factor.
Compatible with Lithonia Lighting fluorescent unit inverters and occupancy sensor switches.
Compatible with LST lengths up to 12' in 2GT8 and 2SP8 fixtures. For LST compatibility in other product families, consult factory.
Electronic Ballast Option
GEB10RS
PROGRAMMED RAPID START
One-, two-, three- and four-lamp fixtures.
BALLAST — Thermally protected, resetting, Class P, non-PCB, UL listed ballast
is standard. Minimum line transient as shown in IEE587, Category A, ANSI-62.41.
Ballast operates at 120V nominal (108-132V) 60/50 Hz, 277V nominal (249-305V) 60/50
Hz or 347V nominal (312-381V) 60/50 Hz. MVOLT (120-277) 50 Hz or 60 Hz.
Ballast meets 1988 Federal Efficacy Standard (Law 100-357) where applicable.
Ballast meets all requirements of ANSI C82.11. Meets FCC rules/regulations Part
18, 15J for EMI/RFI.
Minimum starting temperatures: 0°F for T8 lamps; 50°F for T12 standard lamps; 60°F
for T12 energy-saving lamps.
1.7 maximum lamp crest factor.
Power factor > .98.
LISTING
UL listed and labeled. Listed and labeled to comply with Canadian standards.
LISTING
Minimum five-year ballast manufacturer's warranty.
Specifications subject to change without notice.
BALLAST SELECTION
Actual ballast selection based on specified lamp type (see Performance Table, on reverse side). The following are the standard
number lamp/number ballast(s) supplied per fixture unless otherwise
specified:
Lamps/FixtureBallast/Fixture
For:Use:
To specify one ballast for 3-lamp or 4-lamp operation indicate
1/3 (1 ballast/3 lamps) or 1/4 (1 ballast/4 lamps).
1-lamp fixture One 1-lamp ballast
2-lamp fixture One 2-lamp ballast
3-lamp
fixture One 1-lamp and one 2-lamp ballast
4-lamp fixture Two 2-lamp ballasts
Fluorescent
Sheet #: GEB10PS
GEB10RS Electronic Ballast Option, Programmed Rapid Start
GEB10RS PERFORMANCE MATRIX
Number
Minimum
Lamp
Lamp
Lamp
of
Maximum Ballast Circuit Circuit Sound
Nomenclature
Type
Wattage Lamps Wattage Factor Type2Wiring Rating
GEB10RS
U31
U316
32
1 39
T8, 1-5/8" U
2
62
Standard
.88
T8, 6" U
3195
T8, 48"
RSSeries
A
41114
NOTES:
1 Single ballast operating all lamps in 3- or 4-lamp configuration.
2 RS= Programmed rapid start
ORDERING
INFORMATION
Choose the boldface catalog nomenclature that best suits your needs and write it on the
Example: 2SP8 G 3 32 A12 120 GEB10RS
appropriate line.
Voltage
120
277
347
MVOLT
Ballast quantity
(blank)Standard
1/3 One 3-lamp ballast
1/4 One 4-lamp ballast
Ballast type
GEB10RS
THD<10 programmed rapid start
Lithonia Lighting
Sheet #: GEB10RS
©2000-2011 Acuity Brands Lighting, Inc. All rights reserved. Rev. 11/10/11
Fluorescent
One Lithonia Way, Conyers, GA 30012
Phone: 800-858-7763 Fax: 770-929-8789
www.lithonia.com