Spec Sheet - E

advertisement
FLAT BACK LOW VOLTAGE TRACK
(E-KFB SERIES)
Applications: For general purpose track lighting in indoor commercial, retail, or industrial applications.
E-KFB1EK
E-KFB2LW
Black Finish
1.7"
(43 mm)
White Finish
90° Tilt Range
5.0"
(127 mm)
90° Tilt Range
1" (25 mm)
3.3"
(84 mm)
3.1"
(79 mm)
3.5"
(89 mm)
2.5"
(64 mm)
1.7"
(43 mm)
2"
(51 mm)
4.25"
(108 mm)
6" (152 mm)
Catalog #
Description
Voltage
Lamp
(not included)
Transformer
Aiming
E-KFB1E*
Flat back low voltage
track fixture
Low voltage Halogen12V
MR16
Max. 50W
External electronic
Tilt: Approx. 135˚
Rotation: 358˚
E-KFB2L*
Flat back low voltage
track fixture
Low voltage Halogen12V
MR16
Max. 50W
Internal magnetic
Tilt: Approx. 135˚
Rotation: 358˚
(*) Specify finish color. K=Black, W=White
Performance
Electrical
• 1-year limited warranty
•
•
•
•
•
•
•
•
•
Construction & Materials
• 10W minimum lamp wattage required for standard operation;
20W minimum lamp wattage required for dimmed operation
Deep-drawn steel flat back housing
Polyester powder coated finish
Comes standard with an internal baffle in black finish
This classic shape utilizes has a rounded U-shaped double yoke with a
single-locking knob to secure the aiming angle
Supplied with a clear glass lens, which is secured inside the
internal black baffle
The lamp is held in place by three clips on the interior of the baffle
The baffle is held inside the track head by two spring clips.
Compatible with 1 or 2 circuit track.
Tool-less relamping is done by pulling out the baffle and slipping the
lamp off the three clips.
Regulatory
• UL and cUL Listed
• Suitable for dry locations
NOTE: If you plan to dim fixtures with magnetic transformers, you must use a dimmer rated for inductive loads.
NOTE: If dimming fixtures with electronic transformers, you must use a dimmer rated for use with electronic transformers.
NOTE: Most dimmers that are rated for dimming magnetic (inductive) or electronic transformers
require neutral connection at the dimmer.
Due to continuous product improvement, information in this document is subject to change. All published photometric testing performed to IESNA LM-79-08
standards by a NVLAP certified laboratory. Fixture photometry was completed on a single representative fixture. Actual production units may vary up to
±10% of initial delivered lumens. Lumen maintenance values at 25˚C (77˚F) are calculated per TM-21 based on LM-80 data and in-situ fixture testing.
1501 96th Street, Sturtevant, WI 53177 | Phone (888)243-9445 | Fax (262)504-5409 | www.e–conolight.com
Download