Comments on HO decision and initiation (16.2.6.3.2)
IEEE 802.16 Presentation Submission Template (Rev. 9)
Document Number:
IEEE C802.16m-10/0641
Date Submitted:
2010-4-30
Source:
Shih-Yuan Cheng, Whai-En Chen
wechen@niu.edu.tw
National Ilan University
Shiann-Tsong Sheu, Chih-Cheng Yang
stsheu@ce.ncu.edu.tw
National Central University
Kanchei(Ken) Loa, Yi-Ting Lin, Tsung-Yu Tsai,
Youn-Tai Lee, Chun-Yen Hsu, Chiu-Wen Chen
loa@iii.org.tw
Institute for Information Industry
Yang-Han Lee, Yih Guang Jan
Tamkang University
*<http://standards.ieee.org/faqs/affiliationFAQ.html>
Venue: IEEE Session#67, Bangalore, India.
Re: IEEE 802.16-10/0011, “IEEE 802.16 Working Group Letter Ballot#31a”, on P802.16m/D5
Base Contribution: This is base contribution.
Purpose:
To be discussed and adopted by TGm for 802.16m LB#31a.
Notice:
This document does not represent the agreed views of the IEEE 802.16 Working Group or any of its subgroups. It represents only the views
of the participants listed in the “Source(s)” field above. It is offered as a basis for discussion. It is not binding on the contributor(s), who
reserve(s) the right to add, amend or withdraw material contained herein.
Release:
The contributor grants a free, irrevocable license to the IEEE to incorporate material contained in this contribution, and any modifications
thereof, in the creation of an IEEE Standards publication; to copyright in the IEEE’s name any IEEE Standards publication even though it
may include portions of this contribution; and at the IEEE’s sole discretion to permit others to reproduce in whole or in part the resulting
IEEE Standards publication. The contributor also acknowledges and accepts that this contribution may be made public by IEEE 802.1
Patent Policy:
The contributor is familiar with the IEEE-SA Patent Policy and Procedures:
<http://standards.ieee.org/guides/bylaws/sect6-7.html#6> and <http://standards.ieee.org/guides/opman/sect6.html#6.3>.
Further information is located at <http://standards.ieee.org/board/pat/pat-material.html> and <http://standards.ieee.org/board/pat >.
Introduction
• In current D5 page 275 line 23:
– The AMS shall not perform HO to a cell with Cell
Bar bit=1 in its S-SFH.
– The “Cell Bar” bit, when set, indicates that an
AMS should not perform network entry or re-entry
to this cell.
Motivate
– In page 366 line 37 states that
• If the AMS reads cell_bar=1 in SFH, this which means this
cell does not allow access of new AMS and the AMS shall
select a different cell to restart network entry procedure.
– In page 387 line 17 states that
• If an idle mode AMS is paged by an ABS whose Cell Bar
bit=1, then the AMS shall not perform network re-entry to
this ABS.
– In page 529 line 28 states that
• If Cell Bar bit = 1, this cell is not allowed for network entry
or re-entry
Problem Statement
• In page 529, the AMS shall not perform
network entry or re-entry to the cell when cell
bar bit set to 1.
• Since the cell is not allowed for network entry
or re-entry by operator or the ABS is out of
service.
• Therefore, the AMS shall not perform HO
network entry or re-entry to a cell with Cell
Bar bit=1 in its S-SFH.
Proposed Text
[Modify the following text in section 16.2.6.3.2 “HO
decision and initiation”]
• The AMS shall not perform network entry or re-entry
to a cell with Cell Bar bit=1 in its S-SFH. The “Cell
Bar” bit, when set, indicates that an AMS should not
perform network entry or re-entry to this cell.