612928498
Sheets showing required layout for the preparation of a camera -ready article
/Theoretical and Applied Mechanics Japan
Tarou R IRON * and Hanako O URIKI**
* Department of Mechanical Engineering, Ouriki University, Tokyo
** NCTAM Ltd., Tokyo
These pages provide you with an example of the layout and style which we
wish you to adopt during the preparation of your paper. They have been typed
using a 12 point 'Times New Roman' font in 1.0 (single) line spacing and should
be used as a supplement to the 'Summary' sheet. All text material and
illustrations will be published after a reduction to 80%.
These pages provide you with an example of the layout and style which we
wish you to adopt during the preparation of your paper. They have been typed
using a 12 point 'Times New Roman' font in 1.0 (single) line spacing and should
be used as a supplement to the 'Summary' sheet. All text material and
illustrations will be published after a reduction to 80%.
1. FORMAT
Text dimensions (length and with) for openingpage : 24cm x 17.8cm. Ttext dimensions (length and with)
for all subsequent pages : 24.9cm x 17.8cm. Deviations from this text area are not acceptable.
Recommended fonts : 12 point ‘Times New Roman’. Text length : equivalent to approximately
single-spaced lines. This page is typed in 12 point ‘Times New Roman’with 1.0 line spacing. Do not use
small font sizes for footnotes. (Remember text reduction is to 80%.)
We normally recdomended the use of 1.0 (single) line spacing. However, when typing complicated
mathematical text it is important to increase the space between text lines in order to prevent sub-and
super-script fonts overlapping one another and making your printed matter illegible.
2. TABLES AND ILLUSTRATIONS
2.1 TABLES AND ILLUSTRATIONS
Tables should be presented in the form shown in Table 1. Their layout should be consistent throughout.
Tables and illustrations should be arranged throughout the text, preferably being included on tne same page
as they are first discussed.They should have a self-contained caption. The caption should be arranged on the
table and it should be arranged in the center or left-justify of table.
Illustrations must be original drawings or sharp black and white prints. Please do not use color illustrations.
The caption should be arranged under the illustrations and it should be arranged in the center or left-justify.
3. PRINTOUT
The manuscript please paste clear ones, directly in the camera-ready seat, or print. Printout must be an
original copy. Photocopies are not acceptable. Deviations from this text area are not acceptable.Text must be
612928498
proof-read and checked for completeness. Do not pollute the manuscript which you completed.
Table 1 Do not use color lines. Lines should be sharp.
Fig.1 Do not use color illustrations.
Fig.2 Do not use color illustrations.
REFERENCES
References should be collected at the end of your paper. Do not begin them on a new page unless
this is absolutely necessary. Below we have listed some references according to the required layaut.
1) Kawazoe, Y., " Mechanism of High-tech Tennis Rackets Performance", Theoretical and Applied
Mechanics, Vol.51, (2002), pp.177-187.
2) Schlichting, K., Boundary-Layer, 7th ed. (McGraw-Hill Book Co.,1980),p.53.
3) Kawazoe,Y. (1992), "Impact phenomena between racket and ball during tennis stroke", Theoretical and
Applied Mechanics, Vol.41, pp.3-13.