Setting−Up the Hunt Group in the SPA9000
Document ID: 108822
Contents
Introduction
How do I set up a hunt group?
Related Information
Related Cisco Support Community Discussions
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business
products (formerly Linksys Business Series).
Q. How do I set up a hunt group?
A.
This article gives you how hunt group is being configured on the device; examples of hunt group and call flow
of each Hunt group example.
In configuring the hunt rule, follow the instructions below:
Configuring the Hunt Rule
Step 1:
Click SIP, then under PBX Parameters look for Hunt groups. The example hunt rule that is
on the field is 4089993001:5001|4089993000:5000,cfwd=aa. This means that when a call
comes in on the Line tab that has a user ID: 4089993001 it will go to the extension 5001. The
second hunt rule means, when a call comes on the Line tab that has the user ID: 4089993000,
the call will be routed to extension 5000 and if nobody answers the call will be forwarded to
the Auto Attendant.
Hunt rule sample 1:
Note: The question mark (?) means wild card. So if a caller dials 530, it will ring all
extension numbers with 530 prefix registered on the PBX server. Each extension will ring for
10 seconds and 1 means the number on how may times it will ring the extension numbers.
Hunt rule sample 2:
Note: This hunt rule means that when a caller dials one of the User ID of any Line tab of the
SPA9000, it will always fall to the extension 5300. If nobody answers the phone the call will
be forwarded to the voice mail with the VOICE MAIL ID: 5300.
Related Information
• Technical Support &Documentation − Cisco Systems
Updated: Dec 12, 2008
Document ID: 108822