3M Commercial Graphics 3M Center St. Paul, MN 55144-1000 General 1-800-374-6772 Product Article Letter This letter is in response to your request for a copy of the Material Safety Data Sheets (MSDS) for: 3M™ Controltac™ Graphic Film with Comply™ Adhesive 8640C ES This product is not required to have a MSDS under the Occupational Health and Safety Administration Hazard Communication Standard, 29 C.F.R. 1910.1200 (b) (6) (IV), and 3M has not prepared a MSDS for this product. This product, when used under reasonable conditions or in accordance with the 3M directions for use, should not present a health and safety hazard. However, use or processing of this product in a manner not in accordance with the product’s directions for use may affect the performance of the products and may present potential health and safety hazards. This product is considered to be an article as defined by the Federal Occupational Safety and Health Administration. An "article" means a manufactured item, other than a fluid or particle: (i) Which is formed to a specific shape or design during manufacture; (ii) which has end use function(s) dependent in whole or in part upon its shape or design during end use; and (iii) which under normal conditions of use does not release more than very small quantities, e.g. minute or trace amounts, of a hazardous chemical and does not pose a physical hazard or health risk to employees. If you have any questions about the features or performance of these 3M products, please call Commercial Graphics Division Technical Service at 1-800-328-3908. Additional article statements, as well as RoHS and REACH SVHC information for our films can be found at 3M.com/Regs. Sincerely, 3M Commercial Graphics Product Responsibility Version 1.0