UDP400 Dipole Antenna
Antenna for Use with 400MHz ELPRO Products
Specifications
Parameters
Frequency
360 - 520MHz (1)
Gain
2dBi
Bandwidth
2.5MHz at Center Frequency
VSWR
< 1.5:1
Polarization
Vertical
H Plane
Omnidirectional
Termination
N-type Female(2)
3m (10’) RG58 Coaxial Cable Terminated with BNC Male(3)
Description
Size
0.6m (23.6”)
The UDP400 Dipole Antenna is a ground independent, ½ wave coaxial
antenna, suitable for ELPRO 400MHz product range. This antenna is vertically
polarized with omnidirectional radiation and has a fiberglass radome and
powder coated aluminum mounting pole.
Housing
Half Wave Coaxial Dipole Enclosed in Fiberglass
Mounting
20mm (0.8”) OD Powder Coated Pole - use with BR-COL-KIT
Weight
0.15kg (0.33lbs)
Wind Loading
2.5kg (5.5lbs) at 160km/h (99mph)
The UDP400 Dipole antenna is available with N-type connector or with 3m
(10’) RG58 cable with BNC termination options.
Note: Specifications subject to change.
1) Specify center frequency at time of order.
2) UDP400-C
3) UDP400-3
Termination
General
These antennas require mounting brackets to secure the antenna in place.
ELPRO recommends the BR-COL-KIT for best results.
Ordering
To order, select product code from the table and specify country of application.
Product Code
Description
Frequency
UDP400-C
Dipole Antenna - N-type Female, 2dBi
360 - 520MHz
UDP400-3
Dipole Antenna - BNC Male, 2dBi
360 - 520MHz
1) Specify center frequency at time of order.
Product Compatibility
The following products are compatible with this accessory. Please refer to
product datasheets for compatibility details to suit your application.
Product Code
Description
Data
Sheet #
BR-COL-KIT
Mounting Bracket Kit for Collinear Antenna
7933
The only controlled copy of this Data Sheet is the electronic read-only version located on the Cooper Bussmann Network Drive. All other copies of this document are by definition uncontrolled. This bulletin is intended to clearly present comprehensive product
data and provide technical information that will help the end user with design applications. Cooper Bussmann reserves the right, without notice, to change design or construction of any products and to discontinue or limit distribution of any products. Cooper
Bussmann also reserves the right to change or update, without notice, any technical information contained in this bulletin. Once a product has been selected, it should be tested by the user in all possible applications.
©2013 Cooper Bussmann
www.cooperbussmann.com/wireless
0313
BU-SB13117
Page 1 of 1
Datasheet: 7967