#16 Instructions.Ovation ABOVE CEILING BALLAST ACCESS* BELOW CEILING BALLAST ACCESS* 5 4 1.) Remove scr ew at one end of ballast access plate. 2.) Slip ballast access plate fr ee of housing r etention slots and lift out to reveal ballast. 3.) Remove ballast fr om plate by removing ballast mounting scr ew and slipping ballast fr ee of retention slots. * Above ceiling ballast access not available for multi-ballast, T5 or emergency-lighting models. RE Step 1 LAMP ACCESS CENTER-MOUNT SIDE-MOUNT Access Plate & Flex Installation RECYC LA B ABL O E RES UR LE BIO DE G WARNING: RISK OF FIRE AND ELECTRIC SHOCK. THIS PRODUCT IS TO BE INSTALLED BY A QUALIFIED ELECTRICIAN ONLY. * Illustration shows Center-Mount model. Slide-Mount models have two perforated lamp shields, one main r eflector (retained with scr ews to each side), and no channel cover . Ballast access sequence r emains the same. 1 ATTENTION: CONTRACTOR N EW CE LE DAB RA 3 1.) Remove perforated lamp shield(s) by shifting of f of mounting bolts. 2.) Remove lamps. 3.) Remove main r eflector(s). 4.) Remove ballast channel cover (center -mount models only). 5.) Remove ballast(s) by r emoving ballast mounting scr ew and slipping ballast fr ee of retention slots. Step 2 Step 1. Insert gr ound screw end of access plate into access opening. Step 2. Fold into horizontal position and slide forward into locking position. Grounding conductor (if insulated) to be stripped min. 1" . Insert end of wire into small hole. Wrap wire under and around head of screw counterclockwise (as illustrated). Tighten screw. Access Plate Step 2. Fold into horizontal position and slide forward into locking position. ATTENTION: RECEIVING DEPARTMENT NOTE ACTUAL FIXTURE DESCRIPTION OF ANY SHORTAGE OR NOTICEABLE DAMAGE ON DELIVERY RECEIPT. FILE CLAIM FOR COMMON CARRIER (LTL) DIRECTLY WITH CARRIER. CLAIMS FOR CONCEALED DAMAGE MUST BE FILED WITHIN 15 DAYS OF DELIVERY. ALL DAMAGED MATERIAL, COMPLETE WITH ORIGINAL PACKING MUST BE RETAINED. ATTENTION: CONTRACTOR REMOVE PLASTIC BAGS AND PROTECTIVE COATINGS FROM REFLECTORS PRIOR TO ENERGIZING FIXTURES Access lamps by shifting perforated lamp shields) off of mounting bolts on one side. Allow lamp shield to hinge from opposite mounting bolts, swinging downward to hang as shown.