JAYLUM INSTALLATION
WALL T5/T8 Luminaire
SAVE THESE INSTRUCTIONS
WARNINGS
1) WARNING!
2) WARNING!
– Risk of Fire/Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
– Risk of Fire/Electric Shock. If not qualifiied, consult an electrician.
NOTES
1) NOTE! – This product must be installed in accordance with local/ national electrical codes.
2) NOTE! – Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of kit installation. Do not leave any other open holes in an
enclosure of wiring or electrical components.
3) NOTE! – To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or any sharp objects.
4) NOTE! – Disconnect all power before proceeding.
INSTALLATION OF MOUNTING BRACKETS
USE ONLY HORIZONTALLY
MOUNTED 2”x4” J-BOXES (by others)
AT POWER LOCATIONS.
MOUNTING BRACKET
MOUNT NON-POWER LOCATION
BRACKETS TO STRUCTURE.
Mounting For Single Fixture
43.0” [1092 mm]
4’
91.0” [2311 mm]
8’
Mounting For End Of Row
45.5” [1156 mm]
END
4’
93.5” [2375 mm]
8’
END
Mounting For Middle Of Row
48.0” [1219 mm]
4’
96.0” [2438 mm]
8’
ADE130029
JAYLUM INSTALLATION
WALL T5/T8 Luminaire
INSTALLING FIXTURES
1
Fold in tabs for corresponding
mounting method.
C
B
A
Fold Tab A if fixture to be joined to another fixture (row).
Fold Tabs B and C if fixture to be mounted as single unit
or if fixture is at end of row.
See Page 1 Mounting Bracket Specifications and Dimensions.
Hang Fixture on MOUNTING BRACKET
and secure with included fasteners.
2
Pull wires from J-Box thru end of fixture
for easy wiring while fixture is hanging.
Wire fixture to requirements following all
National and Local Electrical Codes.
3
Tuck wires back into fixture.
ROW MOUNTING
1
Remove Optional Dust Cover (If Applicable)
OPTIONAL DUST COVER
2
Using provided Hardware secure fixtures to MOUNTING BRACKET,
and connect fixtures together as shown.
#10-32 Nut
#10 Star Washer
Make electrical connections and tuck wires into wire cavity
prior to hanging fixture on mounting bracket.
3
#10-32 Screw
Hardware should be positioned
at bottom of keyhole slot and
tightened securely.
Re-Install Optional Dust Cover (If Applicable)
ADE130029
JAYLUM INSTALLATION
WALL T5/T8 Luminaire
INSTALLING END CAPS
1
Install provided fasteners fully, then back out 1/4 turn.
END CAP
Loosen or Tighten as necessary to ensure a
tight fit when END CAP is installed.
2
3
Fit END CAP fasteners into KEYHOLE SLOTS.
1
Press END CAP downward to snap into position.
Ensure fixture is securely supported while
installing END CAP.
KEYHOLE SLOTS
3
2
SUPPORT FIXTURE
INSTALL LAMPS
OPTIONAL DUST COVER
INSTALL APPROPRIATE LAMP FOR FIXTURE TYPE
T5/T5HO
T8
ADE130029