JAYLUM INSTALLATION
Suspended LED Luminaire
SAVE THESE INSTRUCTIONS
WARNINGS
1) WARNING!
2) WARNING!
3) WARNING!
4) WARNING!
– Risk of Fire/Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
– Risk of Fire/Electric Shock. If not qualifiied, consult an electrician.
– Risk of Fire/Electric Shock. Luminaires wiring, ballasts, or other electrical parts may be damaged when drilling for installation of reflector kit hardware. Check for
enclosed wiring and components.
– Avoid contact with LED modules.
NOTES
1) NOTE! – This product must be installed in accordance with local/ national electrical codes.
2) NOTE! – Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of kit installation. Do not leave any other open holes in an
enclosure of wiring or electrical components.
3) NOTE! – To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or any sharp objects.
4) NOTE! – Disconnect all power before proceeding.
CONNECTION AT FIXTURE
12” Aircraft Cable with Barrel Terminals
and Steel Toggles (included).
CROSS CABLE INSTALLATION
1
Insert Barrel Terminal
into keyhole slot.
2
2
Fully insert Toggle into
keyhole slot.
3
Install Screw(s)
1
POWER FEED
CABLE/GRIPPER INSTALLATION
J-BOX
(by others)
1
1
2
3
Slide Cable Coupler onto Main Suspension Cable
and secure Coupler to appropriate mounting point
at ceiling.
Install Cable Gripper onto Main Suspension Cable.
Insert Cross Cable into Cable Gripper and install
thumbscrew.
Cable Coupler
Cable
2
3
Cable Coupler
SJT Cord
Cable
Please refer to Corelite “Connection at Ceiling” instructions
for detailed information on various mounting methods.
Cable Crimp
Loosen thumbscrew to level fixture. Re-tighten
as necessary once fixture leveling has been
completed.
4
NON-POWER FEED
4
Adjust Main Cable to desired length and cut
excess cable if necessary.
! IMPORTANT: Install CABLE CRIMP prior to
cutting cable.
*Fixture shown with LED Downlight Kit
Not all options available. Please consult your Cooper Lighting Representative for availability. Specifications and Dimensions subject to change without notice.
ADE130025
JAYLUM INSTALLATION
Suspended LED Luminaire
MOUNT SPACING
POWER DROPS / KNOCK-OUTS
FIXTURE LENGTH
Power
SAMPLE ROW
FIXTURE LENGTH
96” SPACING
96” SPACING
5/8”-7/8” KNOCK OUT
*For continuous rows see joining sheet.
Break off appropriate KO, slide power cord through KO opening, then
secure power cord with strain relief.
Note: Location of the KO’s varies depending on fixture
JOINING
Install first fixture with two AC cable
assemblies, then second fixture with
one additional cable.
END CAP
Bend out tapered aligning tabs and
fit into aligner slots. (Fixture 2 is now
supported by fixture 1 at the joint.)
Make electrical connections.
Tuck wires into wire cavity, slide both
fixtures together. Secure fixtures using
two 10-32 x 3/8” screws and nuts.
Tighten 1/4 turn past hand-tight.
LED DOWNLIGHT KIT
End Caps: Slide into end of fixture
and secure with two 10-32 x 3/8”
self tapping screws.
LED DOWNLIGHT KIT: If downlight kit was removed
during installation (not required), re-install using
included hardware (four 10-32 x 3/8” screws).
*For continuous rows see joining sheet.
Not all options available. Please consult your Cooper Lighting Representative for availability. Specifications and Dimensions subject to change without notice.
ADE130025